Does anyone have experience or an opinion on ordering marine electronics from BOE Marine electronics?? They seem to have name brand products at a decent price.
My 2006 Four Winns Horizon 180 was ordered from the factory without a depth finder/sounder. Faria and Humminbird both make several that will fit. There’s is the 2” cutout/space with the easily removed “blank” to mount the guage on the far left of the dash/instrument panel. 3 questions here: Is a...
I recently bought an immaculate 2006 Four Winns Horizon IO. The engine motor box cover is made of fiberglass. Is there a good product/material that I could insulate it with in the inside to reduce engine noise. My old 95 Horizon had a wooden engine cover with insulation on the inside and vinyl...
I realize obviously it was super amateur work that was done and knew it was wrong but was just looking for the answer on how it SHOULD have been done. I’m not buying the boat.
I’m looking at a 2001 Four Winns Horizon in good condition to possibly purchase, however there’s one thing I’m puzzled at. I’m told the original owner tried mounting something in the ski locker and drilled 3 small holes in the hull. It’s been removed and the 3 holes have since been plugged and...
I'm looking at a 2003 Crownline 180. Its in good condition. Its carpeted with the original carpeting, in good condition. It is NOT snap out carpeting however. Are those fiberglass molded floors underneath and not wood with wood stringers? Seller didn't know.
What’s the comparison in quality, overall general construction/resale etc between a mid 1990s Four Winns Horizon vs the same era Monterey bowrider both 20’ or under in length. Both mid/upper tier? Or not?
I have a question if my 1995 Four Winns Horizon 190 bilge pump is working correctly. If I switch it on with switch on the dashboard nothing happens, but if I then go in the engine compartment down in the bilge there appears to be a float, if I lift that up it comes on and runs and the red...
Here's a pic of the trim and tilt pump. Is the red cap the "fill" cap? Does it twist counterclockwise to open? I couldn't get it to move and didn't want to force/break it. Is it where I'd check the level?
Just a few questions here before I proceed with diagnosing the knocking/binding noise.
1-What are ALL the symptoms of bad/failing U-Joints? What should I all be watching for?
2-This boat was at the dealer last fall and the drive WAS removed and checked. They replaced the gimble bearing, u-joint...
Thanks for the information. A little more background to what's going on. The fact that it won't hold the drive up for a long period of time is not a new problem, it's been that way for a while. However, the "knocking/binding" noise is a relatively new problem and really concerns me. So whats the...
