Recent content by gill

  1. G

    2001 Evinrude 225 Ficht

    have the 01 225 ficht, twin set up, port engine runs great, starboard engine has trim and tilt power from shifter,you turn the key to the on position and the correct lights come on in the guages but the fuel pump does not run. When you turn the key to start, there is 12v all the way back to the...
  2. G

    merc idle screw setting

    I have a 2004 mercury carb 175 jet drive, what is the idle screw setting
  3. G

    2005 suzuki DF40 dies at idle after run wide open

    This engine dies at idle after you have run wide open for a moderate period of time. But it only does it every once and a while. You can run it wide open draw back to idle over and over again. But about 1 out of 10 times it will die. and then won't crank back up with out using the warm up lever...
  4. G

    how to get starter off 2005 DF40?

    how do you get this starter off? I have the one that has two bolts down through a ring bracket that the starter sits in. bolted from the top. What's the proper way?
  5. G

    DF40 problems

    flashing a code for IAT (intake air temp) sensor, replaced the sensor, code still flashing. Its also idling like crap and sometimes won't idle at all, I think it may be from the ecm not getting the correct information from the iat. Could it be the wiring harness or something else?
  6. G

    2000 omc 5.8l

    Customer has an omc 5.8L- Obviosly a ford engine. First question is does for alternate side when counting cylinders. Or go straight down on side and straight down the other side? Second the engine was sumerged in water up to the exhaust manifolds and will not start now, not even a cough...
  7. G

    idle mixture screw 200 txrr

    what's starting idle mixture screw setting for a 1993 yamaha 200 txrr
  8. G

    Bravo Two only slides back 1/2"

    I am a tech myself and I have this bravo two that will only slide back on the studs 1/2" I was able to disconnect the shift cable from the drive but still won't move any farther than that. I am thinking the drive shaft is stuck in the engine or coupler. Anyone have any fix or procedures for this.
  9. G

    NO Spark on 1993 Yami 200 TXRR

    Here's the deal, I am a marine tech and I have this engine giving me correct voltage from the high and low speed stator coils, and the correct resistance readings. It is also giving correct voltage and resistance from the pulser coils. I have disconnected the white wire at the cdi and still no...
  10. G

    Need Yamaha Flywheel Nut Torque

    Need the flywheel nut torque spec for a 1993 Yamaha L200 TXRR Thanks
  11. G

    Need 1993 Yamaha 200 TXRR torque specs Please!

    I need the torque specs for the cylinder heads, connecting rods, and the crankcase inside and outside bolts. It would be greatly appreciated!
See more
Top