I have 2000 (year) cc 1901 (model) bay boat. Today, took it out for a quick run since its been sitting up all winter. No issues with running it until I got back to the dock. Trailered it and took the drain plug out. Poured water. Looked in the bilge - there must have been 10 gallons back there...
i have a 2000 Century 19' CC. I'd like to know what the max transom weight supported is. Currently has a 2000 yamaha 150 2-stroke on it. I want to add a boarding ladder. I'm not what you'd call a "small framed" guy and am just checking for safety sake.
I'd also like to find an owners manual for...
i know its not peeing out the pee hole. i'm really sure the impeller and tube is all good. once it leaves the tube, where does it go? maybe a blockage? i doubt this motors water passages have ever been cleaned out.
motor started overheating before I changed anything. only time it seems to do it is at idle. if you are wide open down the lake, no issue. i did change the impeller and used the exact same style as came out of it (which wasnt in bad shape to begin with). I have ordered a new thermostat, thermo...
Compression is good. I've pulled the head. Freshwater run only. Isn't there a different cover I need to pull where the water first comes into the block?
1973 chysler 70 hp. started overheating (buzzer going off) when idling. doesnt do it when running down the lake.
Replaced the impeller just because it hadnt been done and i wanted to be sure the key was still there. Reinstalled all that. Ran it in on a hose - alarm went off after about 5-7...
motor is 1973 chrysler 70hp. changing thermostat, so changing head gasket. trying to find the correct part #. the parts 27-F369529-3 and 27-820438 are what im finding, but it looks different. if you look at the attached, my old one has water jacket holes (I assume thats what they are for) all...
perfect. last question: the round opening where the gears mesh has a channel around it that looks like a seal would go there as well. the diagram isnt showing another seal. do i need to seal it with gasket sealer? seems unlikely they would create the channel if nothing went in it.
on the o-ring, it looked like it was one part but it had a circular shape within a tear drop shape, which matches the channel it sits in. is it actually two o-rings, one inside the other? the tear drop follows the contour of the gear box. the circular one seals off the opening where the gears...
I have a 1973 70hp 707hf. I need a water pump gasket. i also need an o-ring/seal/gasket that goes between the the propeller shaft housing and the upper part it mates to. the seal is tear drop shaped and has a round seal inside it. i'm sorry i dont know what to call it and i cant find it on a...
bought a new single binnacle universal throttle. my cable ends at the console look like the attached picture. one is basically bare wire. the other has the old coupler from a very old evinrude shifter.
Question - i'd like to reuse these cables with my new universal throttle. it needs the...
