Just purchased a Crestliner with this 2004 Nissan 30HP 4-stroke. At WOT the most I can get is about 4500 RPM. The manual states the range should be 5250 to 6250 RPM. It also states that with the long shaft version it would come with a 9.9x11 prop. Mine has a 9.9x10 which as I understand should...
Just purchased a Crestliner with this 2004 Nissan 30HP 4-stroke. At WOT the most I can get is about 4500 RPM. The manual states the range should be 5250 to 6250 RPM. It also states that with the long shaft version it would come with a 9.9x11 prop. Mine has a 9.9x10 which as I understand should...
I have a Nissan 30NSF A with a controller that has 4 open ended wires coming out of it. They are black, red, light green, and white. Are they to be used for gauges or a tachometer? I am wanting to install a generic brand tach.
I have a Nissan 30NSF A with a controller that has 4 open ended wires coming out of it. They are black, red, light green, and white. Are they to be used for gauges or a tachometer? I am wanting to install a generic brand tach.
Just purchased my first boat with an outboard. It is a Crestliner Angler 14SC with a Nissan 30HP with tilt/trim. The boat does not have any gauges. Took it out and at WOT it wouldn't go much more than 9.5 MPH as per my GPS. Played a little with trim but not much changed since I'm new to it too...
I have purchased a 2004 Nissan 30HP electric start with less than 50 hours. The spark plugs are new, and the battery terminals have been cleaned. The manual says to loosen the air vent screw on the tank, squeeze the bulb until it is firm, do not raise the Neutral warm-up lever when starting the...
