I mean I can go clockwise turning the barrel nut down as far as it will go or turn it counterclockwise till it nearly separates the two shift rods and it has no bearing on the prop from not ticking and slowly turning when in nneutral unless I slightly push the gear shift handle backward towards...
Thanks for the suggestion, but the jam nut is on the linkage just below the barrel nut. As I stated earlier , I have adjusted the barrel nut from all the was up to all the way down and the ticking happens everywhere in the range. I have to barely push the shift lever back about 1/4 inch and it...
I have not had the lower unit off or the two shift rods separated. I bought the motor used and just noticed the shift ticking after I bought it. Maybe the previous owner had replaced the impellor coz it pees a good stream. I will try adjusting again and make sure it is fully in reverse when I...
I bought a 2009 Yamaha 25 hp 2 stroke long shaft tiller steer. It runs great but when in neutral, I can hear a ticking noise from the prop area and the prop continues to slowly turn. I can push back just a little and the noise and the prop stop. When I let pressure off the shift handle, both...
I guess my triangle shaped plug with all the brown wires is all for trim and tilt-which the motor I am installing does not have. But, yes it is informative info. Thanks for sharing it.
OK, so basically this guy is using new plug connectors, but a plain old spade connector would do the same thing if you put one on each wire and matched the colors. Unless I am missing something. Thanks for the video.
I am trying to put a 1989 Evinrude 25 HP, remote steer, electric start on a boat that had a 1997 Evinrude 40 hp on it. The remote shift/ignition box and wiring harness and steering cables were left on the boat. I have the "big red plug " from the 25 HP- both ends - and the wiring cable that ran...
Yes, I cleaned off the back of the switch and got my young eyed wife to look.. 2 "M" terminals, one 'C" in the middle, one "I" and 1 "A".. Thx for all your help !! Eye Dr appointment has been Scheduled
Crosbyman. Can you draw on the picture of my switch which letters coordinate with the terminals? I havew looked at this switch with a magnifying glass and only see 2 "M" and one "I" Thx for your help
Well. on closer examination my switch does not look like the one in the diagram. I am attaching a picture of the back of my key switch so hopefully someone can identify which terminal is for which wire and let me know. There are no markings on the terminals.
