Recent content by gonecrabin

  1. G

    86 gt200 prop shaft hub stuck

    Hi, I have a 86 gt200 that needs new seals and o rings in the prop hub. I removed the 4 bolts in the back of the hub and still can't pull it out. I am using a puller and a little heat. How much heat is too much, and is the hub located in the housing radially. I want to tap the puller to...
  2. G

    GT 200 smokes alot

    Hey guys, I have a 1986 gt 200. The engine runs great but seems to smoke a lot. I have used the Johnson and Mercury oils, they seem to be the same. I cut back a little on the premix, (vro disconnected), didn't help. It mostly smokes upon start up. Any thoughts?
  3. G

    '86 gt200 spark plugs

    Does anyone know the best plugs for my '86 200? If so, can I get them at an auto store? Probably need the maker of the plug's model number. Thanks
  4. G

    replacing 200 vro pump with standard 140

    I was woundering if I can use my 1977 140 fuel pump on my gt 200. I already premix. I tried useing one of the two pumps from a 83 200, but after gettting on plane for a minute, ran out of fuel. Or can anyone recemend a pump? Thanks
  5. G

    electric fuel pump '86 gt200

    Does anyone know if it is ok to use an electric fuel pump '86 gt200? Thanks
  6. G

    wires going to gt200 fuel pump?

    On my '86 gt 200, what are the wires going to the fuel/oil pump? Thanks
  7. G

    86 gt200 fuel pump?

    Hey guys, my 86 gt200 is starving for fuel. I want to get rid of the whole fuel/oil pump system and replace it with an electric fuel pump, what do you guys think. thanks for any response.
  8. G

    '86 johnson gt200 primer

    Hey guys, I'm working on a 86 gt200 I just bought. The idle is a little rough. I started going through the normal stuff, when I got to checking the primer, I pulled the hoses off of the primer body but stupid me didn't note which came from which nipple. One, hose has a white stripe on it, I...
  9. G

    alpha 1 gimble bearing stuck

    Hey guys, I'm new here and would like some help with my '96 alpha 1. I am replacing the gimble bearing but can't get the old one out. After looking at my Selco book, it says something about a snapring. Is there a snapring that has to come out before I use a puller to remove the bearing...
See more
Top