2020 235LR, Merc 6.2 300hp, 2A636272 engine. Anyone know where the temp sender is on the engine ? Found a 2 wire temperature sensor but I think its for the ECU..Only one I can find on the diagram. Thanks..
I have surge brakes on my 2013 tandem axle Eagle trailer. They don't run a ground wire for the reverse lock out solenoid. It grounds through the ball.. I noticed since I painted the top of the ball yellow to see it better on camera, I lost the ground.. So I have to run a wire. My previous...
2013 Stingray Cuddy, the round Bomar hatch on top of the cabin leaks between the aluminum frame and fiberglass deck... I am wondering what to use for sealant. I've read, butyl sealant, 3M 4200 sealant, Dow 795, etc...
Looking for a boat hull cleaner that is also safe for my painted Eagle trailer.. Don't have alot of grime, some discolored hull & water line from being in the River for 2 weeks.. I tried one product, "biodegradable", it worked on small area, but noticed it discolored a diamond plate trailer...
Faria depth sounder on new to me 2013 Stingray 215CR, worked for 2 days in water, now it blinks 00 or gives wrong readings. Found transducer in the bilge, I'm assuming its a "in hull"...On vacation, need a depth sounder... Checked connections and seem OK. Any suggestions besides going to marina...
I need to replace my reverse lockout brake solenoid on my 2010 EZ Loader trailer. Where it's located the bottom frame is open and I may be able to get a wrench on the brake hose fitting. Question how do I remove the brake hose without it getting twisted? It seems to run the length of the trailer...
2010, 3.0 MPI. I removed the spin on water separator/filter and the center threaded post came off with the filter. It's threaded in the housing,smaller thread,& had some sealant on it. So do I put some type of sealant on the threads(Permatex red thread lock or Form-A-Gasket 1) and screw it...
So in order to check the accuracy of my single wire temp gauge/sensor I also disconnected the 2 wire "Digital Coolant" sensor next to it, so I'd have more wire. Now when I turn the key on instead of a short alarm I get a long one and while leaving the key on I also get one beep...Will this...
My temp gauge is off by about 25 degrees since new 3 years ago.. Checked with 2 Infrared digital temperature meters at the sending unit/thermostat housing... If I change the sensor or gauge will that "maybe" help?? Or just live with it...
Re installing Gen 2 drive and have a 1/16 to 1/8 gap between the upper housing assy and bell housing assy. Just wont go the last fraction. Thinking that it's the large rubber "O" ring keeping it out?? Correct ?? Thanks...
There is rubber washer, 12-77674, just above the oil seal for the lower shift shaft. How is that positioned on the shaft, do I push it against the seal or let it set half way on the shaft?? Alpha Gen 2 Thanks
