FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I see only a slotted-head screw or plug toward the port side of the trim rod housing. Is the the hydraulic fluid fill plug? I downloaded both 2006 and 2007 Owners manuals and neither even mentions existence of hydraulics much less where to fill the fluid.
My raise/lower ability has decreased noticeably over the last month. I can still raise the motor enough to get the manual supports in place, can adjust the planing angle OK up and down, etc. BUT I cannot raise the motor quite enough to put the manual stops in place without some hand assisted...
My engine has low hours, maybe 100 on it. The symptom was that it would start just fine and run for about 3 or 4 minutes and then quit. Stumbles,quits. I replaced the entire fuel path from the tank to the engine including line connectors and squeeze bulb, filter at the engine, etc. Bypassed the...
I've seen several posts about the steering cable being stuck in the tilt tube. I have yet to find a foolproof method (or modification) that allows me to force grease into the chamber INSIDE the tilt tube where the steering plunger must slide. Afraid to try to dri Also, I have yet to find a...
