Recent content by hamburgerman

  1. H

    big foot 50 is it worth it??..

    OK we have a 19foot pontoon weighs 2500 full gas and 2 passengers 50 4 stroke big foot wot.5800 sometimes runs 6000 prop 14x10p speed gps 15.5/ 16 at best if i get more passengers or pull a tube it slows considerably,although i do not see any bogging down still at 5800 wot its like the power...
  2. H

    Big foot 4 stroke wont run past idle in the water

    I have a 50 hp 4 stroke big foot sreial # OG961361 wouldnt run when I got the boat ex owner said he thought the carbs needed rebuilt ... I did an ohms test on the ignition parts all looked up to specs except the controller/computer pack part number 8250981 replaced that and on the muffs it...
  3. H

    6 hp tiller lower unit replacement

    I changed out the water pump now I cant seem to get the lower unit to line up . I have done it 3 other times over the years with no problem ,I bet I got about 15 hrs. in trying this. first time it went right together then i noticed that the shift linkage was wrong so i pulled it back apart...
  4. H

    50 hp 4 stroke wont stay running

    Ok so i bought this boat from a guy that let it sit for 4 years 99 50 big foot I get it home fires right up on muffs I ran it in the driveway 10 mins then i flushed tank and started over with fresh fuel ran good and fired right up every time till it got in the water started right away...
  5. H

    Fishing seats stuck in floor

    I just bought a 19' thats been setting for 3 years. the removable fishing seats in the front have been taken off the poles and set in the holes. The guy I bought it from, said this is common for these to freeze in the holes and just to pound them out. I pounded and pounded but no luck...
  6. H

    Drain plug hole

    I have a 12 foot aluminium fishing boat that has no drain hole whats the best way to install one without makeing a bunged up mess out of it?
  7. H

    6hp mercury fuel pump

    I want to replace the fuel pump diaphram on my 6hp mercury Iboats shows a few but I don't know witch one to get I can't find the part number s# 2255633 m# QD-23R any help would be appreciated
  8. H

    lower unit replacement shift rod does not match up

    I am replacing my lower unit 86 Johnson 115 tlcrd I bought one from an 88 spl looks good and bolted right up but shift rod was nowhere close.I pulled it off and the bend at the top is different no way this will work so I guess my question is can I easily swap these shift rods around I searched...
  9. H

    dead batery again

    I have 115 hp johnny tlcrd if I do not disconect the battery it goes dead after about 2 or 3 days . I do know that it is charging , Any info on where to start looking first would be greatly appreciated
  10. H

    wanna go for a ride (see video)

    I thought motor heads would like this, I did . Check out this video...
  11. H

    Trim motor replacement

    1984 johnny 115 I bought a new trim tilt motor and have had trouble finding a new seal o ring tried to use the old one, stil leaking. anny help would be appreciated.
  12. H

    lower unit info

    will a 78 100 hp evinrude fit my 84 johnson 115 ? thanks I have been looking to get back on the water most of the summer!
  13. H

    lower unit swap need to know if they will fit

    Johnson 115 bad lower unit # J115 TLCRD have found E 150 TRL CTE lower unit anybody know if these will interchange?? thanks
  14. H

    84 115 missing

    I rebuilt the carbs. Pressure tested the fuel pump. New plugs. Did link and sync. Starts everytime, but runs rough at any speed. Dies at low idle after 10+ seconds. Fires right back up. Did spark test, looks like is sparking good on all, but all plugs are equally wet and oily when I take...
  15. H

    long shaft to short

    I have a long shaft lower unit, and a short on mine (that is toast). would like to save and swap driveshaft and use the outher one 100 hp the units are the same except driveshafts and shift arm length can this be changed out easly or am I in for trouble? I had no luck with the search crap...
Top