Recent content by heflins

  1. H

    Pulse Limiter Sensor

    I posted earlier and forgot to mention What I found with the Pulse Limiter Valve. I know this is there to protect the VRO pump from a hard backfire I guess my question is what would happen if a PLV is stuck open I removed mine there was no carbon or anything like that but I did find it was stuck...
  2. H

    Evinrude 200 stalling and runs only at idle

    Evinrude 200 1998 I have about 50 hours on rebuilt power head , I cleaned and rebuilt carbs when powerhead was installed Motor ran great other than sometimes being a little hard to start 1st thing in morning but fired very easily the rest of the day. I was out last weekend temp was about 58...
  3. H

    Evinrude 200 shifting Problem

    After getting my motor put back together from a rebuild I have noticed that when I am in forward gear when I shift back into neutral it takes a couple of seconds to come out of gear. I Installed the powerhead my self and did not change the gear cable adjustment I did not have this problem...
  4. H

    evinrude 200 lines on Intake

    Evinrude 200 1998 Vindicator/ Carb/ If you are facing the carbs with the air silencer off on the Intake where the reedvalves are located there are two fittings that come straight one is toward the bottom the other is a little higher. What connects to these fittings one of mine had a plug on it...
  5. H

    Where does this go?? Evinrude 200

    Help I have a 1998 200HP Evinrude Vindicator I had the powerhead Rebuilt and am installing it my self. My question is I have a Rubber line the same size as the fuel lines from the fuel rail to the carbs. On this line is a check valve. The picture I attached shows #(42) the checkvalve=line in...
  6. H

    What does this do

    I have 1998 Evinrude 200 Vindicator on the Port side of my engine sits the VRO2 Pump beside the pump there is a solenoid with 2 hoses coming from the top going to the carbs. Does any know what exactly this does. There is also a red lever that you can turn and it appears to have a schrader valve...
  7. H

    Evinrude 200 Vindicator/runs backwards

    Where do I start.Bought boat, when I first took boat out the idle was rough and very hard starting,after warmed up boat would start great and would always run great past idle.Took boat out about 7-8 times and it blew up.Rod looked like a twizzler after all was said and done. Sent power head out...
See more
Top