That makes more sense now. Sometimes the exploded diagram gets a bit confusing when they try and fit everything on the page. As always, a wealth of information on here from a bunch of different people and each and every one is appreciated! Scott
Can the prop slip on the hub? The diagram shows an 0 ring in front of the prop but I don't see one. Would that be between the prop and the hub? Is there a way to check the hub? The cheapest prop i can find is $55. That's not bad at all but I hate to buy it if I don't need it. Thanks again.
Thanks for the advice racerone. I just dug up the service manual and was looking at it. It does look simple but you know how that goes. Not always so simple! I hate to tare it apart in the middle of duck season but I'll see how that goes. I'll start with the prop. It's the original. Thanks again...
We went duck hunting this morning at a lake with lots of tree tops. Afterwards, when coming up on plane, It was like the clutch slipped every now and then and would over rev. In open water, after it slipped a couple more times, it ran fine at full throttle. "Coming up on plane", nice try, its a...
I have a 1999 Bayliner Capri 2050, 5.0, Alpha 1 gen. 2. Mercruiser stearn drive. It seems to shift fully into forward and reverse with no problem. My problem is when approaching a dock or when putting it on the trailer, it's hard to "find neutral". I have to pull it past neutral a little bit...
I have a 1976 6hp #6604A Evinrude outboard. I need the throttle cam settings. Does the front edge of the cam follower roller or the center of the follower roller have to line up with the two cam marks? I've done this before with a throttle shaft amplifier hooked to the carb shaft. I just...
