Recent content by hogluvr

  1. H

    BF100 out of time?

    Thanks guys, I had the carb soaking for 3 days. They’re simple enough, guess I could take it back apart and try again. BTW the carb was spotless inside the first time I took it apart. I’ll try to find that passageway
  2. H

    BF100 out of time?

    Ok I’m starting to get stumped. Soaked the carb and nothing changed. Looked like the timing might be off a tooth so changed that and it wouldn’t start. Not sure where to go next?
  3. H

    BF100 out of time?

    The guy I bought it from had cancer, the guy who gave it to him had the same cancer and died so I doubt it is anything big, so far any issues I have had are simple. I have no idea how long it was stored but it was serviced before it was, pretty apparent. I think like Alumarine suggested the next...
  4. H

    BF100 out of time?

    I’ll try cleaning the carb first. This is a new-to-me motor, just got it running. Runs fine at idle
  5. H

    BF100 out of time?

    Or maybe carb adjustment?
  6. H

    BF100 out of time?

  7. H

    BF100 out of time?

    So she is running now but bogs when I give her gas. I’m thinking it may be out of time? And I’m still trying to find the correct impeller for her so I can replace it, it is apparently a pre-80’s motor.
  8. H

    BF100 out of time?

    Here is the back story https://forums.iboats.com/threads/what-do-these-2-rubber-hoses-go-to.772963/
  9. H

    What do these 2 rubber hoses go to?

    Looks like Sierra doesn’t make parts for this motor?
  10. H

    What do these 2 rubber hoses go to?

    Seems to be working just fine to me but I’m still replacing it because I have no idea how long this motor was sitting
  11. H

    What do these 2 rubber hoses go to?

    Yeah I was gonna ask about Sierra. I’ll dig into the manual tonight to see what else is involved, looks like I may need gaskets and other things. Just hope I get the right one, I plugged my serial number into Honda Marine and nothing came up! 🙄 I sid some research and the best I could date it...
  12. H

    What do these 2 rubber hoses go to?

    I do remember reading that they should be replaced if they have been stored for a while. Should I go OEM or would aftermarket be ok? I only ran the motor maybe 10-15 seconds at a time at most, hope that didn’t screw anything up!
  13. H

    What do these 2 rubber hoses go to?

    Yeah I noticed the intakes look way different from what I’m used to seeing, and I obviously haven’t seen a lot! Might have to look into a barrel, would like to here her run for a while before I take her out
  14. H

    What do these 2 rubber hoses go to?

    It’s alive! It’s alive! Decided to set the points to the correct setting and try again, had to be coaxed for a bit but she’s finally running! Couldn’t run her very long because I don’t have a set of muffs, but sounds great! Thanks again for all your help and patience! 👍
  15. H

    What do these 2 rubber hoses go to?

    So I’m trying to make sure this thing is in time. The grainy pdf manual that is hard to read says when the marks line up on the flywheel and the pulley the points should barely start to open. First, it’s hard to watch them line up when one of the supports for the pull start is in the way...
See more
Top