Recent content by hondapapa

Motor runs good at speed ,But does not get enough clean air to idle with cover on. How do I fix this ?

Can the motor be removed without taking outdrive off of boat ?

Where Is the water pump on a 1995 cobra 3.0 with cobra out drive ?

Does a car or truck engine and a boat I/O engine turn in the direction?

I have a 1995 Manitou pontoon 24 ft with a 1995 90 hp force motor. Wood has got to be replaced before splashing this year.I do not want to use wood.I have some 1 1/2 inch aluminum plate,but I was told not to use it because it will not flex. Somebody said to use plastic instead. What do yall think?

1977 skeeter with a140 Johnson. I need to oil or grease the unit under steering wheel, don't see a grease fitting.what do I need to do?

Why is an exhaust leak into the intake bad for the motor ? will this cause damage?

Will the engine block from the 77 engine fit on the 78 lower unit?

I have a aluminum bassboat that leaked for years. What do I use to replace the foam ? And where can I get it ?

What parts except stator may be bad ? What do I need to check ?

I have a 1977 Johnson 140 hp with problems found a 1978 Johnson 140 cheap . Will parts interchange ? Need to know if I should buy it.

I was idiling up to dock and motor started ratteling then skipping. it cut off,and now it wont turn over,sounds like a dead battery but battery is new. motor is a 1977 johnson 140. I have a shop and do most of my work myself. Dont like to pay some one else. where do i start? can fix most...

Should the gas cap be vented on a small outboard motor with the tank on it ?

1969 eska 3.6 hp what is oil/gas mixture,and should gas cap be vented? thanks

I have a 1969 eska 3.6 hp, what is the oil/gas mixture? Should the gas cap be vented?