i have a 1976 evenrude 6 hp, is there any way to tighten the throttle on the handle so it stays where u set it, mine wont hold and keeps going back to slow or stop
how do you tighten the tension in the handle to hold speeds, when i let mine go it goes back to idle or stop, i want to set it and hold the speeds for trolling, is there any adj or a spring somewhere? please e mail me , reowheel@ejourney.com
if anyone is looking for a trim and tilt assy i have a 1989 omc motor and single ram assy with engine harness, reconditioned. i had to replace with new while on vacation(ouch-very expensive new). make a resonable offer, e-mail me if your interested reowheel@ejourney.com--not doing me any good...
i have a mariner trolling motor,the bearings are binding and noisy,runs very very slow,need new bearings and a seal kit. any suggestions as to where i can find some parts?
my brother has this motor and he states that it is a force made by merc,anyways---he is telling me that he has a water leak where the lower end bolts to the engine housing(6 bolts) is there a gasket at that location(he says there is one that has pieces missing) he said that all of a sudden it...
i have a mariner 21 lb thrust trolling motor,foot control. is there a kit or parts place to get some parts for it? the motor runs but very slow,i can feel and hear the bearings grinding. it needs new bearings. also is there a schmatic as to how it comes apart and how to reseal it. it dont look...
i have a 1989 mariner mag 40 4 cyl,it seems that the oil injection is smoking much more than normal,smokes very bad and seems to be running rich. is it possibe for me to disconnect the oil tank and just add oil to my fuel tank? as i dont trust the pump system anyway. also what would be the...
