A friend Hit something yesterday and broke almost 1/2 of the skag off ( the back half) must have hung the Log or big stick/ no prop damage. 75hp/merc/ about a 98yr md/ Now His boat will not plane off. Would the missing piece cause this? Prop still engages fine.( you can turn engine with it...
Trying to replace the Imp& shift shaft boot on this thing. where do you find part's for these cross breed motor's??? the sel# plate is faded so bad I cnn't read the # . DO i get merc. part's or force part's?
I'm looking at buying An 1984 cheetah 166. It needs a new transom seal/boot. How hard is it to do/ I've never done one this old. IT's a older omc sterndrive
94/seadoo gtx I put put new starter on it it ran 30 min and quite. Now it restated but ran 15-20 sec. and now i have no fire HOW do i ck the 4 wires comming out of the stator without pulling the flywheel. or what else do i need to CK frist
i just got a 1988 glastron gx-219 -o/d sel 0c377755/ 260v8 alpha one and the shift bellows is bad. were can i get info on repair. and it does not have a exhust bellow. should it have one
I have a 1999 Johnson 25 hp 3 cylinder. It started out quiting on me sometimes after running for about 30 to 45 mins. I have been running it on the hose and it started loosing fire on #2 cylinder. Then it lost fire on all 3 cylinders. Checked power going into all 3 coil packs (none). Checked...
this is a 2000yr carb/200 hp it will start run 2 or 3 sec. and dies. I have checked fuel supply and it getting gas /it does not appear to me to have a real good spark. Some of the vac. lines were off and i am not sure they were put back right . Got to start somewhere ,any help i will try it ...
94 evinrude 50hp VRO. I want to remove the lines and pump / can i just pull them all and install a elec. pump. I don't think the one on here is working right /it is filling carbs with oil and flooding real bad ,so i pulled the oil hose and hooked to a tank of 50/1 and it ran better
well i took the merc off and set a 50hp vro on my daughters boat. Guess what? It has no fire at all. THE controls are the ones that it was running with /starter turns motor good , have 12+ volts on the 3 terminals at rear of treminal block , but no fire at plug wires . How should i CK stator...
