i trying to see if there are any other shops that sale these pins for snap button installation. sail**** has them but its alotta money for a 1 time tool. so anyone else seen these ???
Does anyone make button covers with a round top for when you dont have the carpet in the boat you can snap them in place to cover the button? they are not too comfortable to have your bare feet on.
What are some ways i can diag the depth sounder gauge in my 2000 sea ray 230?.Its a factory installed gauge and im assuming the transdocer is inside the bilge area cuz there is nothing on the transom. The gauge wont even come on in the water. i checked it has power to it though.?????
Just picked up a 2000 searay 230 select with 7.4l efi engine and bravo 3 outdrive. The problem is the serial number cant be read on the top engine cover....where else would i find the engine serial number? I want to change all the fluids,filters,sea water pump,serpentine belt,spark plugs etc...
I have 1 silver bottle of "quicksilver high performance" gear oil and I have 2 black bottles of mercruiser "high performance gear oil + " are these 2 gear oils the same? Can i mix them? Want to change out the gear oil in a bravo 3 drive.
thanks
:eek:
just replaced trim and sender switches...trim gauge works and reads when sterndrive is raised...but i can raise it all the way with the up trim button the limit switch is not stopping it....when i move the limit switch the rams do not move at all...also the trailer button on the quick silver...
well so far so good i did not have to remove the stearn drive nor the gimble ring i was able to access the 1 retaining bolt with a 1/4 ext and 7/16 wobbly..bolt came right out...now the hard part one of the trim limit screws is being a biatch to get out...have sprayed it with penetrant,apply...
i am thinking of switching out the stove type choke i have on my mercruiser for the electric conversion i have seen for sale. I dont think the stove mounted one on the intake manifold works anymore or works very little. has anyone done this conversion?
i have a 91 5.7l gm engine and went to change the thermostat because it still had the original one in it but i cant seem to get the sleeve above the thermostat out!!?? is there a trick? special tool? witch doctor dance? i have to do to get the sleeve out? by the way the sleeve looks to be brass...
here is a pic did i put it on backwards? i say its right..friend says its on backwards? and no i don't use tie downs i just need new straps....:D
http://s928.photobucket.com/albums/ad125/Drfeelgood67/?action=view¤t=biminitop005.jpg
I have a 1991 trailrite trailer with 14x6 rims using e78-14 st tires. The stamps on the brake hub read as follows:
UNIQUE FUNCTION AC PRODUCTS
HD-1377-10
122
D18CARD PT-10.040
can someone decode and recommend what kodiak kit i need to convert? I know i will need a new surge controller,reverse...
Can i install speakers in the fiberglass engine shroud??? (i have an i/o) Anyone ever installed speakers in the bow area??? or how about installing speakers in the fiberglass walk thru area how ever i dont know mounting speakers 20 inches apart facing each other is a good thing...anyone have any...
i have a 1990 monterey scr206 bowrider and im looking to find the walk thru piece of glass for the middle. anyone know of a place to get them or boat junkyards? i have contacted the glass maker and it would have to be made for a price im not willing to pay. The piece of glass slides into a u...
