My num 2 cyl was not hittin so i thought it might be the coil on that cyl. to check this i switched out a coil that was working and didnt make a difference. I switched them back and now my num 2 and num 4 cyl are not firing according to my light. any thoughts?
my engine will idle fine, will cruise at a low speed greatly, but when i go to put the foot down it bogs like its getting too much fuel and smells like its flooding....what would cause this?
This maybe a idiotic ? but when you move the little switch on the solenoid it makes the motor run real fast (lean) move it the opposite direction it bogs it down. Should i find the happy medium position on the switch or is there a specified position for the switch?
Well the problem is that the motor takes awhile to get up out of the hole but once it does it runs fast and good. I have no problem with it starting and it stays running...im at a loss. Any advice?
