Recent content by imokintex

My no oil light comes on and stays on, and every now and then the constant horn goes off for a few seconds. I replaced the water pump and checked for overheating. Engine runs cool. It is smoking quite a bit (not excessive)so I believed it was getting oil. I unpluged the 3 wire connector to the...

I have a 1998 130 Evinrude. Below my bottom carb on the passenger side on the intake there is some kind of brass valve screwed into the intake cover. It has a large line coming from it going to the Oil pump. It also has a vacume line coming out of it that has come loose and I cant find where it...

I bought a 1974 evinrude 135 on an old boat. I got the motor running but the choke is not working.I think someone before me changed the choke solonoid to an incorrect one. I have a choke solonoid with one ground wire and 1 purple/white wire. When I called a dealer I was told the choke has 2...

I have a 1974 135 Evinrude V 4 with no spark on any plugs. I took the sensor wire off of the power pack and grounded the sensor terminal of the pwer pack while cranking and got a spark. Does this mean that the timer base assembly is bad. Seems to me if you ground the sensor and the power pack...

I have a 1986 150 hp suzuki with a bad piston. I found a 1995 150 powerhead complete with wire harness fuel injection, electronics and controls. Can I swap out the powerheads(will it fit?)?

I have a 1986 150 hp Suzuki. I am replacing 2 pistons because of oiling problems. I want to remove the oil injection system when I rebuild the motor but I was told I can not do that because the flow sensor on the oil system is linked to the computer and the engine will not run over 3000 rpm. Can...