Recent content by imthemedic

  1. I

    Does anyone have one of these?

    This is a discontinued fuel tank selector valve. It haas on a 91 Stratos 201. No one has them. I have called 10 Stratos dealers, Stratos themselves, and T&H Marine who made them and no luck. My hope is someone might have one lying around. I broke a barb off of mine so if you have one with the...
  2. I

    Problems Problems Problems 91 200GT

    Sometimes I think it would be much easier to get a different motor lol. So heres the deal, I got them otor running fairly good but it just had some minor idling issues. I had just redid the lync and sync and it was the best it ever ran, but still not perfect. I decided to change my stator...
  3. I

    What size bolts for flywheel puller in 91 200GT

    I have an automotive puller but I need different bolts as mine aren't even close. Any idea what size I need.
  4. I

    Rectifier or Stator

    I still have that off an on tach issue. It doesn't bounce around it's either working or not. Usualy at idle it's off then when I get up on plain it will pop up and start working. It may or may not stay on. I know my stator has been hot and I will be replacing it next week. My question is would a...
  5. I

    How can a bad stator effect performance

    My motor starts and idles fine. It just doesnt seem to have the get up and go it should have. I have checked the spark and all cylinders are fireing when you crank the motor. I can see where the stator has been warm before as the plastic has melted in a few places.
  6. I

    How to set WOT Timing without a test wheel?

    I have a 91 Johnson 200GT that i need to set the WOT Timing on. I can do the Lync and Sync but need some help with WOT timing. I heard there is a way to do it without the test wheel and out of the water. Could someone please post the process?
  7. I

    Increase Idle Speed?

    Question for you....On the lake in neutral it idles ok at about 1050 rpm, when i pull it in gear the idle falls to around 600 rpm and the sneeze starts and the missing usual kills the motor. Do you think i should retard the timing a little it's 6 degrees now ATDC? And or turn the trottle arm...
  8. I

    What causes no bottom end power?

    Ok I thought it was the prop that was the problem since i bought the boat this year, but after trying 4 different props all that run boats the same as mine I have concluded it must be the motor. When I launch the boat engine revs to 2500rpm and then slowly climbs up in rpm. Takes about 15...
  9. I

    Stator? Engine issues

    I have noticed my tach works 80% of the time. It's not an issue with it being erractic but more its working or not. I have jiggled wires and it doesn't change anything. The motor seems to lug a little out of the hole and may or may not have everything on the top end. And of course there has been...
  10. I

    Renegade by OMC and Renegade BASS what is the difference?

    What is the difference between the two in 13.5x25?
  11. I

    Lean Sneeze , Miss at idle

    Well I bought the boat after sittin a year or so and it's had this miss all year. It seems to be running great abouve 1200 RPM. I have replaced all the fuel lines from the tank to the VRO, New filters and water seperator, New Evinrude Bulb, pulled the carbs, cleaned and blew out all the jets and...
  12. I

    Driving lights but no brake or turn signals?

    I have the standard single light on each side that serves as the driving, brake, and turn signal light. Well the driving lights work but no brake or turn signal? Head lights on or off its the same issue.
  13. I

    Lean Sneeze? HELP

    I bought this 91 200 GT this winter and it was a fresh rebuilt powerhead with about 10hrs on it. I have had it out several times and it has a low end idle miss. It coughs and dies under 1000RPM. I bought a manual and pulled the carbs yesterday and cleaned them up and blew out all the jets. They...
  14. I

    Question about inline fuel filter?

    I have a glass inline filter under the cowling. When I pump it up before starting it is completely full. After starting and running for a while it looks like the filter is a 3rd full. Is this normal?
  15. I

    Cold Engine Idle RPM?

    Well I did my first sync and carb cleaning today. Seems like the motor is running a little better on the water hose. My question is 1400rpm on a cold motor to high? Is there a fix to this? I let it run on the hose for several minutes with no change. 1991 200 GT
See more
Top