Recent content by ineedabrew

Doh. I miss typed the subject. Yes it is a V-4cyl. I'm replacing the head gasket from an overheat and wanted to find the length of the head bolts to see if I shold replace them. They are in good condition physically but wondering if the had stretched, etc. I have no manual to reference...

Hello all, I thought I would ask if anyone had access to an old Evinrude manual. I have a 1966 Evinrude 60653 60 HP 4 cyl Vtwin I'm working on and I need some specifics. Thanks ahead of time for any help.

What I meant to say was a temperature gauge as mentioned above....not thermostat. Yes it already has a thermostat.

Yes, if I end up reviving this think with a rebuild or I luck out with no damage, I would love to put some kind of Tstat on it.

So be sure to check your water pump impellers. This one was just a couple years old. Unless I am mistaken, my 1966 Evinrude 60653 has no tell-tale stream. I was pretty confident impeller was ok, boy was I wrong. Maybe a crappy part that I purchased. In a matter of minutes, I overheated the...

Hello all, I need some help removing my rack steering cable. 47 years of wear caused my steeing cable to bust it's seams. I have removed the rack from under the helm and am trying to detach the cable from the outboard portion of the engine. I don't want to force anything as I don't want to...

Ok everybody, My tilt on my OMC (HU 16C) ​​inboard/ouboard got stuck in up position. After research and plenty of help from this site (THANK YOU!), I pulled the clutch housing apart to find bits of the worm gear shaft pins that sheared off. My question is, Can I just replace the spring pin that...