Hi all we have just fitted a Honda BF35A engine today to our boat.
We have attached our battery power cables to the starter solenoid & earthed at the starter motor.
We attached the engine kill/emergency switch connector then placed the choke/fast idle to the start position & turned the ignition...
Hi all, we have just purchased a Suzuki DT65 (to replace our Chrysler 30hp on our Mayland 16.5ft fishing boat) with power trim/tilt & 2 gauges.
This is the 1st gauge,
When we start the engine the red oil light extinguishes, & the 3 green lights show nice & bright.
However the water & oil flow...
Re: Help with my Chrysler CV30 outboard
The information I can read from the plate is "model number 307 HOC outboard motor, serial number 1241 (I think as is hard to read).
The plate states HP CV30 & 21-2".
There are wires (green, red, blue, yellow & black which I beleive attatch to the...
Hi all this is my 1st (of many I hope) post.
I have a Chrysler model number 307 HOC outboard motor, serial number 1241 (I think as is hard to read).
The plate states HP CV30 & 21-2.
The engine starts on the first turn of the key however blue colored smoke was visible when tested in an outside...
