Does any one know where I might get information leading to how to remove a powerhead to this motor? How to get it apart from the beginning. Starting with the removal of lower unit just a total tear down. My starter mount where it attaches to the front of the motor is stripped and a small chunk...
I have a 1992 j30teenr and i found a broken bolt on the inside of the engine cover that came from the starter bracket in the front above the carb. Also i noticed the one on the side above the battery relay is missing also, it looks as if it was broken too. i guess these are stud bolts with...
here is the problem, motor is bogging out when i try to open it up. runs at 3/4 speed fine. changed impeller and it ran fine now it is doing it again. My son took it out, pulled the cover off and it ran fine. put cover back on and it started to do it again but not as bad he said. could the...
I have a 1992 30 hp johnson JTEENR need to change one first time doing it so any and every piece if information well be very help full. Motor has spacer to convert into long shaft on it. I undid 4 bolts and ther one on top but motor won't drop. Pulled screen covers off on botton of LU shift...
this is the problem on the tiller handle on the very end there is a knob that you tighten down to keep motor at a constant speed kind of like cruise control for mainly slow speeds well it is broke i can't hold that speed when i'm hand lineing. How hard is it to fix? i keep losing fish...
This is my problem when i try to go full throttle my engine starts to miss like it is starving for fuel. it will idle all day when i hand line i can run 3/4 speed no problem it is just when i try to open it up all the way is when the problem occurs. also if i crank the handle to full throttle...
I have a 1996 30 hrse johnson tiller with electric start the first problem is the starter seems very slow even with a new battery, may get one start off it then it's like the starter doesn't have enough to push flywheel then i have to pull start. Does it seem like the starter needs to be...
i was idleing down the lake in my pontoon boat when all of a sudden my 30 horse johnson burped then just shut down tried to restart but to no avail. it has always ran fine. Now i am getting no spark at either cylinder. opened the control box up and cut the kill switch wire pulled its ground...
