I have a problem with my 2004 searay sun deck. The trim gauge on the smart craft is intermittent in the trim position. Gauge works fine in trailer mode but as soon as you lower the out drive into any trim position the needle bounces around like crazy. I have already changed the both the limit...
I had my Eng Computer read and now after my Smart Craft Depth Gauge just shows dashes. I tried resetting the Smartcraft and still the same. Also I've tried to calibrate it still no help any ideas?
I have a 2004 5.0 Merc with a Bravo 3. I get a Check Engine Light on the Smart Craft only when the Engine is over 3500 RPM. I had the computer read and the only message is Steering Circuit. Not sure where to start? Why would a Steering Fault be only over 3500 RPM? Please Help...
