Recent content by J.R.

  1. J

    Water in Oil - 2003 Johnson model J70PL4STC

    150- 180 lbs compression on each cylinder Water gets in oil and engine will sound over heat alarm with high compression doesn't seem head warped or gasket damage, oil level rises due to water what are most likely causes?
  2. J

    2003 Johnson 4-Stroke Series J70PL4ST

    1. Where do The 4 Wires Go to? ( I assume the 2 Black to Negative and 2 others to Positive) 2. Is The Black Filter looking thing a Fuel filter? if so Is teh Line in from Tank the one closest to boat and the one nearest me the out to Motor? 3. Do I need a Fuel line with in line pump going to the...
  3. J

    Ignition Diagram ( 2002 tahoe Blue Ridge SE Fish-n-Fun)

    70 HP 4 stroke Johnson ( Bombardier)
  4. J

    Ignition Diagram ( 2002 tahoe Blue Ridge SE Fish-n-Fun)

    I am Looking for a Diagram to know what King of ignition to buy for my Newly acquired Pontoon, Its at a Family members house and i need to buy Ignition switch ( unless there is a way to use one without a key) before I go and start work on replacing that, the fuel hoses and Clean it up. Would...
  5. J

    What Model Johnson is This?

    J2376973 I have looked at but i can not tell what model motor I have, s help would be very appreciated Thanks in advance
  6. J

    Oil Leaking on the cavitation Plate from (where?)

    OK I have a Pic that shows Once I put My motor in a position as if I was gonna run it a day later I noticed Oil on the cavitation Plate which seems as if it Leaked Fron the screen which I assume is the water intake. Could someone Clue me in on to how this could happen? what do I need to look...
  7. J

    Correcting Air Around My propeller

    My Boat is a bit Newer and set up for Larger Motor Than I have. Facts: 1. The Nose Cone of My Boat is Barely at the Bottom of the Center of the Transom. 2. The Propeller Creates a Large swirl of water and while running you can see where water isnt even touching the motor shaft a good ways...
  8. J

    1962 Evinrude Lark IV (Gear Slipping in half throttle)

    I have a 1962 Evinrude lark 4 (IV) Manual Shift Runs like a dream motor however at lower than half throttle it never misses a beat and pushes my 1977 17' Basshawk boat just fine. once I reach 1/2 throttle it starts to slip and higher the rpm the more it slips so I must run at less than half...
  9. J

    Spark for 1962 Evinrude lark IV (40hp)

    I have a 1962 Evinrude Lark 4 40hp outboard Manual Shift, (35531M) 2 cylinder I was having issues trying to figure out how to properly connect the ignition switch, the motor started fine a few times once i finally figured out how the wires ran per some other iboat forums and wiring diagrams...
See more
Top