Recent content by j_jtaylor

  1. J

    1985 Yamaha 40hp 2 stroke Runs Rough at Low RPM

    Hey there people, just wondering if anyone has had the same problem I'm having as in the motor idles fine but runs rough and surges down low, but once in the higher RPM range goes like a dream!!! Easy to start, and I have changed the plugs and drained the carbies??? Any help greatly...
  2. J

    92 115hp Yamy Water Flow

    Im not sure if this is a problem or not but, I have recently had my 1992 115 Yamy rebuilt, and there doesnt seem to be a lot of water comming out of the top exhaust holes. The motor is running like a dream and not overheating at all?? Am I just not looking at the right time or could it be a...
  3. J

    Yammy 92-115Hp Water Flow

    Gday again, Im still a bit concerned about the water pressure on my outboard, before I had it rebuilt it seemed to have much stronger pressure at idle than it does now. Generally what is the pressure at idle supposed to be?? Also my mech told me that there are flow restrictors that fit in the...
  4. J

    Oil Control Unit 92 115 Yamaha

    Gday again all, anyone know if its possible to get the wiring harness ends for the oil contol unit (The thing that sits on the port head with the switch to pump oil to the engine tank) one of mine is shot and I dont want to pay for a complete unit when its only the connector. Or if anyone knows...
  5. J

    Weak Tell Tail pressure 92C115

    Gday again all, just wondering if anyone has any ideas as to why my pee hole pressure is so low I have just had the engine rebuilt completley but the water seems to be going straight out with the exhaust. The mech has the boat again to find the problem but I thought someone here may have seen...
  6. J

    Transom worry 1969 Savage Bluefin 23ft

    Gday all, been reading all the transom problems people have been having and regard myself as in the same "Boat" so to speak. I have an old 23 foot fibre glass boat that the transom appears to have a lot of rot in, but, there are no stress fractures in it nor is there any movement in it. One...
  7. J

    Lower Crank seal

    Gday again all, I have just been told that my 92 115 may need a new lower crankshaft seal as the drive shaft has fuel and oil residue on it, it has been running very rough at low rpm's does this sound fair??
  8. J

    Yamaha 92 115

    Gday all, I have a 92 115hp yamaha that an audible alam goes off whenever I stay over 4000rpm for any length of time, I dont lose power or anything and no visual alarms appear (Low Oil ect) if I drop back to below 4000rpm for 1 minute or so its fine again. I had a new impella put in in November...
See more
Top