FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Correct but everything was fine before rebuilding head and for about one hour after rebuilding then just went dead and will only bust off not crank all the way
I made sure when I pulled it apart that I match all push rods and rocker to where they went.
I was finally able to do compression test
#1 130 psi
#2 130 psi
#3 140 psi
#4 130 psi
Seams little low I would think this needs to be around 145 150 ?
Also u can't adjust the fall on this motor, there is no valve Lash spin motor to top ded #1 tighten bolts down to 20 ft pounds
Then spin...
It does not have a water fuel separator on it idid check the fuel no water in it but smelled old and dark yellow tint I just put that gas in 3 week before this happen. It did burn off but not at what I think it should have I am going to get some new fuel in a can and put my pump on a small tank...
Hello I have a 192 classic wellcraft with the
MERCRUISER MODEL 165 (2 BBL.) MERCURY 224 I/L4 1987
470 4 cylinder 3.7L just rebuilt the head from blown head gasket, was lossing water and come to find out it was dumping water on #1 cylinder, replaced the intake, exashuast, head, exashuast elbow...
