Hi. Can anyone tell me the most likely cause of having water getting into the trim/tilt hydraulic system. Could it be through the trim cylinders seals?? The oil in the resovoir is milky. We have the system which has the plastic resovoir with the vented cap. The boat is a 4.3L Mercruiser 1990.
We have fitted a hydrofoil to our mercruiser 4.3L with alpha one drive. The boat is planing much faster but the boat leans to one side when planing. We have checked the mounting of the hydrofoil and it is central and square. If we raise the drive up slightly the boat levels out. I know many...
We have a mercruiser 4.3L and there seems to be a strong smell of fuel when idling. All fuel lines have been checked for leaks and are OK. The plugs have been checked and have no signs of fouling due to richness. Any ideas or is this normal
I have 2 cracked manifolds on my mercruiser 4.3. I was going to try and repair them but after reading the advice on here have decided to but new. I cant afford to buy genuine merc ones so which manufacturer of aftermarket manifolds would you recommend cos I have heard that the Chinese made ones...
The throttle on my mercruiser seems to be quite stiff. I have checked the routing of the cables and they are fine. I was just wondering wether it should be this way or is there something else I could check/lubricate. It is advisable to remove both the cables and try to spray lube down the sleeving?
I have a 1990 4.3L Mercruiser. We bought it at the end of last season and noticed it was quite difficult to start when cold and would sometimes miss a little until warmed up. So I am giving it a service before this season starts. I checked the manual and the type of sparkplug which was...
Hi,
I want to winterise my mercruiser 4.3L 1990 model. I have taken out 1 drain plug on the exhaust elbows on each side and 1 on each side of the block at low level. I want to know if there are any more to take out. For some reason I thgought I read somewhere that there are 2 on each side of...
I have read that the engine oil to be used in my mercruiser 4.3L should be SAE 40 and have the letters S/F in the spec. I have found this silkolene oil for sale online and was wondering if someone could advise me on whether it would be ok to use?
2 x SILKOLENE RACELUBE 40 (sae40) 4 litre TINS...
Hi,
I have a 19' V-hull Picton Royale made from fibreglass construction. It has a 4.3 Mercruiser and an alpha one stern drive. It all sits on a 5.5 twin axle rollercoaster trailer. Can anyone tell me the approx. weight of the complete set up because I am looking for a new vehicle for towing it...
I have recently bought a 1990 mercruiser 4.3L. I started it up today with muffs on the drive to bring the engine up to temperature to check all is good before we take her out next week. The problem I have is the temperature gauge did not move up at all when the engine had been running for...
Hi,
I have recently bought a mercruiser 4.3L 1990 with an alpha one sterndrive. I was told it would be a good idea to change the water pick up impeller because the boat had no history with it. So, changed the impeller today but when removing the lower drive housing lost a fair bit of stern drive...
Hi. We recently purchased a boat with a mercruiser 4.3L V6 engine. We want to change the impeller and obtain a workshop manual for the engine. How can we find out the exact age and model of the engine. We guess it is around early 90's. We have seen some manuals online for a 4.3L and 4.3LX but...
Hi
I am looking at getting a boat for skiing and wakeboarding. I have looked at a 18.5ft with a 4.3l mercruisier and also a 17ft with a 3L mercruiser. Which do you think would be the better boat to get. Is there a big difference in fuel economy? Both boats are around 1990 models. We have done...
