Recent content by Jamz33

  1. J

    Mercury 4.0 hp

    Made in Belgium. 2 cylinder. 2 stroke. It’s a mercury gnat.
  2. J

    Mercury 4.0 hp

    Do you have a link? Also what about an impeller.
  3. J

    Mercury 4.0 hp

    I am working on a mercury 4.0 hp and I’m trying to find a carb and impeller for it. Serial number is 9118728.
  4. J

    2002 crownline 305 mercruiser

    Thank you!
  5. J

    2002 crownline 305 mercruiser

    If so how do I plug it?
  6. J

    2002 crownline 305 mercruiser

    Just installed this motor and noticed oil dripping from this hole when around 2000 rpm but wouldn’t when just idling. Is this a crank position sensor hole? If so the other motor didn’t have one.
  7. J

    2003 Crownline oil reservoir fitting

    I have removed the dribbler valve from the bell housing and will be plugging that hole. I have taken a bell housing gasket and flipped it to where the hole where the dribbler valve was will now be covered. So the hole will be water tight. No water should leak back through the transom because the...
  8. J

    2003 Crownline oil reservoir fitting

  9. J

    2003 Crownline oil reservoir fitting

    So the only way the drive vents is thru the reservoir hose?
  10. J

    2003 Crownline oil reservoir fitting

    Plugging off the line to the bell housing should be all I need to do correct? Since the transom fitting nipple is broke there is no way I can plug it from the outside. And water shouldn’t leak back through as long as the body of the fitting is intact I believe. Any other advice? Thanks.
  11. J

    2003 Crownline oil reservoir fitting

    I have done that. Can I block off that hole where the dribbler valve was so no water can get in the drive and leave it like that for now without it hurting anything?
  12. J

    2003 Crownline oil reservoir fitting

    I understand. I know the drive would have to manually checked instead of being able to check the reservoir or go off the low oil alarm. But is there anything that would be hurt from me blocking it off? I just put the motor in this boat and it was a pain to say the least. The engine sits back in...
  13. J

    2003 Crownline oil reservoir fitting

    The oil reservoir fitting nipple has broke. There is enough left of the nipple that we could get a hose on it but it I don’t know how confident I am about it staying on there and worried about it coming off while it’s in the water. My question is I can’t even see the fitting from inside the...
  14. J

    2002 Crownline 5.7

    And yes I want to find the problem instead of mask the problem.
  15. J

    2002 Crownline 5.7

    Thank you. I’m going to clean it tonight with some MAF cleaner and see what happens.
See more
Top