I have a 1996 Johnson 112. The idle is set a little too low. I'd like to bump it up a couple of hundred rpms. Can you tell me where the idle screw is located. I've been through my Seloc manual and cannot find that information. Thanks
Does a fuel disconnect serve any other purpose than that? I never use a portable fuel tank and prefer not to replace my defective disconnect unless I have to. Can't I just make up a permanent connection?
Thanks
I have a 1996 Johnson 112 SPL. I want to hook up a water pressure gauge. Can you tell me where on the motor is a plug I can remove in order to do this? A picture would help greatly. Right now it is hooked to the "Tell Tale" line, which I do not think is the right place. I would think it should...
