is there anyplace i can download a manual for an AQ275 i am about to remove one from an 86 bayliner to see if i can save the transom
bayliner is missing the motor it was a 305 chevy
i just picked up a 1966 marktwain that some one has installed a newer volvo AQ275 with a a 260 B motor i...
Can i install an MC 1 in place of an Alpha 1 boat is a 1987 with the 4.3
i have 3- outdrives a 1979 898 mid 70s,888 and a 74 165 straight 6
i realize that the gear ratio is not quite right 4.3 should be 1,83-1 and the others are 1.65 or 888 is a 1.50-1 ( why did the old 165 hp 6 run a higher...
i have a 1993 mercruiser 5.7 Sn OF 277191 the power steering is real hard at low speed works fine at high speed
have checked and lubed the cable and steering points every thing moves freely .
first time i took the boat out the power steering pump was out of fluid PO left a bottle of trans...
i just bought a 1997 4 winns bow rider with a Volvo Cobra SX OD motor block is junk interior is junk no canvas but the price was good
i am trying to decide if i want to fix the boat or part it out or save the OD for different boat
how good are these SX Drives, if i get crazy and want to build...
i have a 1993 Alpha 1 with a remote gear lube tank SN OF235939 i would like to do a pressure test on the boat does the tank have a check valve or should i just pinch the line?
if i pressure test with the drive off how do i plug the hole?
i noticed last year that it seemed to leak by the oring...
Transom SN OF326150 OD SN OF 235939 1993 Crownline 21' cuddy
my power steering is real stiff until almost wide open throttle then it loosens up
i took the steering cable loose and it moves real easy the out drive was a little stiff and i can feel the pressure on the steering rack when i...
i have a 1993 alpha 1 drive sn OF235939 transom sn OF277191 is there a grease zerk for the top of the OD where it turns
part manual does not show it and i cant find it
and is there any grease zerks on the power steering rack one is shown on the parts list but i cant see it on my boat
having...
This has a 5.7 SN OF277191 Thunderblot IV ( anyone have a link to download the correct manual for this?)
PO installed an older engine in it an i am trying to get it all sorted out
i have 2 wires with connectors that fit the coil stud but seem to be connected to ground
one is in the...
ok the boat is a 1993 Crownline 21' cuddy 5.7 SN OF277191 at least that is what it is suppose to be
PO put an older motor in it 1st question is timing the manual says to ground a purple/whit wire that comes off the front of the distributor i don't have one ?
that section also talks about...
i have a 5.7 chevy that does not have a baffle or windage tray in it
how important are those in a boat
how is the stock mercruiser one mounted? do they use studs on the main bolts or are the main caps drilled for studs?
thanks for the help
i have a 1994 Alpha1 od that some one put a older style Crate Motor supposedly 350 V8 with the 2 piece rear main in the boat
motor has a bad vibration (Even with the OD removed ) i cant see anything wrong with the fly wheel or coupling and have changed the harmonic balancer.
i thought...
i am looking at a 1993 boat with a 5.0 ford OMC Cobra that is shot
can i put a 302 out of a 1974 mercruser in place of it or will that be a mess
like will i be able to use one of the couplings or get one that fits the old mortor and nwe drive shaft
thanks
i have a 1980 celebrity 19' openbow 305 chevy 228hp
i am trying to figure out if my motor coupling is slipping and then locking up again or slipping slightly i would think that if it slipped real bad a couple of times it would just let go and continue to slip or if i have a bunch of props that...
i have a 1980 228 Mercruser SN 5765260
is this OD considered a pre Alpha OD the chiltons says it is a Model 1 or I or does that mean Alpha 1
i need to adjust or replace the lower shift cable and i find all different instructions on the setting of the lower shift cable my Chiltons says 6.25"...
