Recent content by JDA

  1. J

    Fisher Boat Help!

    I recently bought a 1998 Fisher 16 Pro Avenger V-boat as a second,small water boat. The instrument panel shroud which is the molded plastic cap that houses the gauge cluster & switches is cracked and needs replacing. I tried the local Tracker dealer who said it was unavailable. I think several...
  2. J

    Which prop?

    I have a Key West 186 Bay Reef 25" transom w/Johnson 140 4-stroke, long shaft engine. Recommended RPM range is between 5600-6200. I borrowed a ss Stiletto 14 X 22 prop off my other boat for testing which has the same engine except w/short shaft. The Key West boat w/ 20 gallons gas, 2...
  3. J

    Torsion Axle Shot?

    I just bought a used rig w/WESCO trailer & Tie Down Engineering single torsion axle. The torsion cords/bushings are obviously shot because the tires are worn real bad on the inside, no shock action with the torsion arm almost touching the frame. I can see that the camber is way off. Question...
  4. J

    2004 Johnson 140 4-stroke

    This engine has around 600 hours on it. I have used recommended type & weight oil since new, changing the oil and filter at recommended intervals, fresh water use only. Never had an error code or any work performed other than new plugs, fluids and filter change. A couple weeks back I noticed a...
  5. J

    2002 90 HP Yamaha TLRA 2-stroke

    I need to remove the drive shaft (not prop shaft) from the lower gear case. Is this nut right or left hand? Anything in particular I need to know? I'll buy a manual if a rebuild is possible but for now I'm just evaluating damage. Thanks for your help.
  6. J

    2002, 90 HP TLRA Yamaha lower unit

    I just purchased a repo boat powered by a Yamaha 90. I did all research possible prior but couldn't locate the previous owner to find out what actually happened. Anyway, the lower unit was lying in the back of the boat with the prop shaft assembly fully intact but lying beside the gear case. The...
See more
Top