1990 Commodore Regal with Volvo Penta IO 454 GM. Power steering is very stiff. steering fluid resevoir full with no leaks. Engine was recently rebuilt and not sure if it is a self bleeding system or needs to be bled of any air? Power steering pump and belt seems to be OK.
Have 1990 Commodore Regal w/ 454 and Volvo Penta IO. Idles fine, runs fine at Low RPM and runs fine at high RPM with no load (in Nuetral). When under load though once i get up to about 3000 RPM engine rapidly looses power (rpm). Almost like its starving for fuel??? Check ignition dist cap and...
hi gang,
i have an 87 four winns that needs a good polish and wax to bring out the faded gel coat. can anyone reccomend a good product thats readily available
thank you
jeff
hi gang,
i have an 87 four winns that needs a good polish and wax to bring out the faded gel coat. can anyone reccomend a good product thats readily available
thank you
jeff
tyring to get her started for first time this year. Have a mercruiser 3.0 140 hp engine. No Spark,
tested coil and get good spark on high tension wire when i phiscally open and close points with screw driver. However when i test under normal cranking condtions , i dont get spark at high tension...
I have a 1987 four winns and where the drain plug fitting is in the transom it appears that the sealent is bad.... the fitting is a plastic fitting that is held on the transom with 3 scews and has an insert to screw brass plug in. can anyone reccomend what type of sealent i use to seal this...
Hi,
I am looking at the possible purchase of a 93 four winns vista with the above named engine and drive. Can anyone provide background information on inhearnet issues with these engines and drives, and help with good questions that should be asked before purchasing?
thank you
I bought a transom seal kit with all bellows to replace on my 1987 Alpha 1 IO. Can someone steer me to some directions to follow so i can accomplish changing out the seals and bellows. Im doing this because i have been getting water in my bilge and highly suspect from bellows. Do i need to pull...
mecruiser 3.0 Alpha Drive 1987 oily water in boat
i have my boat at marina and go use it every weekend. the last few weekends i notice when doing my pre checks that i have a couple inches of water sitting in my bilge that was not there the week before. there is also coating of what may be...
Was doing a tune up on my 3.0 litre this weekend and when checking timing i noticed that my handheld tach was 900 rpm off from my console tach. We verified that the handheld was correct by trying another handheld my friend has. So im a bit stumped as to why my console tach reads so high. I see...
Hi,
!987 MERC 3.0 w/ Alpha and am going to change out the trim pump resevoir due to finding excessive fluid under and around pump.( all fluid lines look OK) and the fluid accumulates right around the pump under the resevoir(white plastic). My questions is after i change out out the resevoir and...
Hello,
I recently purchased a 1987 four winns powered by a 3.o litre mercruiser w/alpha drive. I notice that if I leave the boat in the water after 1 week of non use that i will take on a few inches of water in the bilge. Rain not the issue... Im wondering if i should change out all the outdrive...
Well got towed into the marina this weekend..... I have a 1987 Four winns hoizon 190 with mercruiser 3.0 engine. Has run great for me all season. This weekend we were out boating all day and we decided to stop for a swim. When i turned off the ignition key the engine sputtered a couple times...
