Jeff J's latest activity

  • J
    Jeff J replied to the thread Sticking weather seals.
    Thanks, I was thinking maybe some tire talc or baby power since they work well as lube for installing inner tubes in tires. Wasn’t sure...
  • J
    Jeff J replied to the thread Sticking weather seals.
    Thanks but looking for a solution that keeps the seals from sticking to the side they shouldn’t stick too. There are a lot of products...
  • J
    I dropped a Yamaha seal into the lake when it stuck just long enough to not fall back on the engine a few years back. I glued that one...
  • J
    Jeff J replied to the thread Creaking/popping power trim.
    Good question on the grease fitting for the pivots. After I made my comment above, one of the new Hondas came through. No popping yet...
  • J
    Jeff J replied to the thread No telltale Nissan 90hp.
    Not much can go wrong with the housing unless it was run out of the water. It can’t pump water if the housing doesn’t hold the cup in...
  • J
    Jeff J replied to the thread No telltale Nissan 90hp.
    Just noticed it is not stated the impeller has been replaced, just checked. How is the impeller being checked? Is it actually being...
  • J
    Jeff J replied to the thread No telltale Nissan 90hp.
    Are all of the water pipe seals where the pipe slides into the water pump housing in good shape and installed properly? Did you replace...
  • J
    Jeff J replied to the thread Raising outboard higher.
    Good to see you got it fixed. Before outboard jet drives were really available from the motor manufacturers, I worked for a boat...
  • J
    The guy needed the trailer for a different boat so he took it back to the lake before I had a chance to fiddle with it again. He sent me...
  • J
    Replaced the high pressure filter and ran on the lake today. No change. I guess it could be going into a guardian mode but not getting...
  • J
    Jeff J replied to the thread Tilt / Trim Motor Torque Specs.
    I spent 20 years wrenching on military aircraft. Used a torque wrench on nearly everything and was taught the wrong terminology. Very...
  • J
    Jeff J replied to the thread Creaking/popping power trim.
    One of the boats I look after has a zerk on the starboard end of the pivot tube but not on the port end. Another one doesn’t have any...
  • J
    Just started getting a 1000 rpm surge at high power settings going across the lake. Not feeling a miss. I think about 1100 hours on the...
  • J
    The circled bolt should be the fill level check.
  • J
    Jeff J replied to the thread BF200 power loss at full throttle.
    I didn’t hear anything for 2 weeks but today they said it is acting up again. It only seems to happen when the boat is pushed hard. The...
Top