g-70 -14
im looking for front windshield black rubber gasket (missing) im also looking for a gasket that bends on my starboard windbreaker window and information how to install it
is there some kind of snake that i could run threw the pick up line from above the tank to try to push the screen or debree out of the pick up tube into the tank
with my boat in the drivway my rule bildge pump is going off every few minutes without water coming out?
it does pump the water out when there is water inside bildge area
thanks for all the feedback, i cut the and heat shrinked the 2-harness togethar (i found a old one and used a couple feet of it with the good 8-pin plug
so far running great again, i have another plug now in case this spice goes bad and i also have purchased a starter jumper if i get in a jam...
has anybody tried to buy another 8 pin harness and just cut and spliced the wires togethar and throw out the old one without replacing the whole harness wiring mess at the helm.
a pin broke on the harness 8-pin connection in the engine as of now the boat is still pretty solid
im not sure if i have many other options i already purchased the wiring harness that i will need
mechanic came to the boat unpluged the harness said one of the pins were loose cleaned the female end and put some electric grease on connections pluged it back togethar engine started right back up and ran perfect before that only idling
he said it was the plug
my boat engine recently stopped running and had to be towed because of a plug that is inside the engine cowl
this plug is a 8 pin male and plugs into the engines wiring harness 1993 or 1994 225 hp mariner 6 cyl out board engine
i am not sure that i need to replace the whole harness that i...
can anybody tell me if my 1986 22.8 hydra-sport has kevlar reinforcement, i have not been able to find serial numbers on the boat or any information about it.
i was told buy the original owner that it was built with the reinforcement.
where is the serial number plate?
