Ok hooked up a jumper and it ran. Noticed positive terminal is pretty corroded. Going to try cleaning that off and seeing if it is going to end up being a quick fix
starting a new thread because I think it’s a new issue. Model number and pics for reference posted below
I have. 2001 evinrude that just got a new/used power head installed. Ran great before connecting it.
Took it to the boat ramp it started and I got it to the dock to park my car turned it...
The wires at the bottom of the PDP, I removed those and plugged them back in and it now turns on without blowing the fuse, I couldn’t get it started because I think my batteries are a little low, but that’s where I’m at now
Also I believe that’s the ignition relay. And ya tilt trim still works fine accessories work. Emm will still power on and self test when I turn the key on etc with no code or warning
The piece it runs to that I thought was the emm is actually the power distribution panel I’m pretty sure if I remember when I did a brief trace it’s not going to the emm it’s with a bunch of other wires that go to the boat itself but I’ll try to check today
