Recent content by jiml100

  1. J

    johnson 3 hp sea king 1967

    anyone know where the water should **** from on these when they are running. also what is the fuel and oil mixture on these older models ? thanks for any info.....
  2. J

    evinrude 60 hp short shaft 1991

    i have a 1991 evinrude 60 hp 2 stroke short shaft with controls and cables off my tracker bass boat, runs great,, starts right up, just had it checked out by shop, new oil pump and fuel pump, new water pump. anyone have any idea what i could get for it if i sell it, i put on a new 4...
  3. J

    4d batteries

    anyone know anything about 4d batteries.... my friend has a couple that hold 12.4 volts after charge, wants to give them to me for free, will they work in my bass boat for my trolling motor ??
  4. J

    control box

    looking for a control for my johnson 60 hp on my tracker .. its a side mount concieled, can be either one of these....
  5. J

    fish finder help

    any suggestions on fish finders ? right now on my bass boat i have a eagle fish id 128 for the rear. and my front one is a lowrance x-65 which is not mountied right now since i bought the power drive v2 with co pilot, i cant figure out how to mount the transducer on the trolling motor because...
  6. J

    1991 evinrude pro 60 hp

    its on my bass tracker. runs alittle rough at idle and seems kinda low, anything above 3200 rpm it runs perfect. anything below it will run good then shutter and come back it does it about every 10 seconds or so.. any ideas ?
  7. J

    jump starting motor

    i have a jump box i carry just incase... can you start these motors and then run them without a battery hooked up or will that damage something in the circuits ?
  8. J

    evinrude 1991 pro series 60 hp

    on my tracker boat. anyone know what the amp output is on the charge system ?
  9. J

    live well over flow drain

    91 tracker bass boat has older 2 hole livewell one fill and one bottom drain with standpipe for water level, work terrible because drain goes uphill to where it exits... putting in top edge water level drain what size fittings to use ? 3/4 or 1 1/8 ? thru hulls. didnt know if 3/4 would...
  10. J

    1993 tracker tx 17 bass boat

    has pro 60 hp johnson outboard. looking for the throttle shift control box with trim switch in handle, with push button nuetral in center of handle. mine is gone need whole control box i have the cables there. thanks..
  11. J

    fish finders

    any suggestions on what the best fish finder for my bass boat is nowadays. i have duals on my boat, back is a eagle strata view 128 and the front is a lowrance x65. thinking of upgrading....
  12. J

    transducer mounting on trolling motor

    i have a minnkota power drive v2. if i mount the transducer on it the fin is below the transducer about 2 inches, will that affect it or should i get a spacer so it is all the way down even with fin ? oic included.. thanks..
  13. J

    trolling motor battery

    i have a minnkota power drive 55 # thrust 12 volt motor, will this battery work ok on it ? Everstart Auto/Marine Battery Group 24 500 cold cranking amp
  14. J

    carb rebuild

    1991 evinrude 60 hp 3 cylinder. carbs need rebuilding, i have rebuilt carbs on my cars alot, so could i probably get away with doing my outboards carbs too ? trying to save the $ 450.00 they want to do it..
  15. J

    minn kota 55 # 12 volt power drive

    got it for a gift, how does that stow away work. im used to the old pull up and let it down mount. this looks like you have to tilt up and slide the shaft up to lock. anyone use them is it a pain in the *** ? thanks
See more
Top