ok putting a 16 ft larson on a bunk trailer. i think its way to high it sits 4 inches off keel roller and outer bunks are holding back off in center. how do i need to set it up
ok so i got a 2004 cobalt 246, no motor or drive it was 7.4 bravo3. so can i put my 383 stroker in front of a bravo three? what other drive will fit in its place? the 383 is built for super charger if needed. i have time but i was looking for options......496 bravo 3 would be sweet but...
i thought i posted this but must have got lost. my boat trailers got brackets for side bunks. i would think they would rub up the sides. so im thinking to remove them and put the upright guides on the rear any imput
I can always tell when another year has passed on the forum. the posts for the quick fixes start. probably like mine two years ago asking about transom, stringer and floor repair. lol its funny because first there is denile and we research pourable stringers blah blah blah. I only have a...
Re: gimble ring removal
I hope picts come through. I should have said the drive is off and apart. im going to warm up the areas and oil them . the cotter pin came out fine I wasn't sure how the pin came out. the forward trim cyl shaft is stuck to....nothing has fought to much just need...
I have an 898 outdrive, how do I get the lower pin out? does it go down or up into housing? I tried to read manual but I get a black screen . how does the steering arm and upper com out? and last how do I get the gimble bearing out? does it have to turn or just drive out?
how straight am I supposed to fair my boat? sounds silly but im used to high end body work. I am fairing in low spots but what about waves in fiberglass.......I know the polyester prime will fix a lot of it. just wondering if you guys block and prime the boat or just smooth out everything...
my boat is an 1980 marlin....wiring is still there and other than some stuff in the bilge area is still not cracked or hacked up. normally I would change it but im not sure new wire is any good lol I see a lot of wire failures in new cars. what do you think...jimmy
so I figure since I hang out here most of the time, ill let you know what a fun day I had. I had my out drive housings media blasted. they were corroded so I figured id paint them up nice. well while sanding out some gouges my upper fell and dented were the bellows go. the outdrive is...
I have a 898 set up for my boat and one of the manifolds are missing. should I use the set of aluminum manifolds and risers and run through the transom or look for a newer used set of center rise manifolds. just one of the options I have
I came to this forum a year ago trying to fix a floor. Lol I enjoy reading all the I nee??d to fix my floor posts. Its like stages of senile. Finally you realize there is no easy out and you join the ranks of the itchy and scratchy club. All your friends think you are crazy. Just patch the...
OK my 305 898 is toast so I am building a 350 for it. My machinist called isky and they recommended a 280 h cam for my boat on 110th lobe separation. Its like 2200 to 6000 rpm. I know this is wrong. Any help guys
