Recent content by Jimmy627

  1. J

    Mounting a pedestal seat

    I have a 1995 Sea Ray 195 br which came with back to back seats on both side's & a Fiberglass Floor. I Purchased a New bucket seat & a Springfield fixed height pedestal with swivel & slide, that i want to install on the driver's side. I went to West Marine & they told me to use & I purchased the...
  2. J

    4.3 Plug Gap

    Does anyone know what the Spark Plug Gap is for a 98 Merc. 4.3. The plugs are NGK BPR6EFS. The Boat is a 1995 but I had the Motor Changed & the Service Manual I have is for a 93-97 4.3 & I don't know if they are the same Gap. The Plug's up to 97 are NGK BPR6FS @ a .40 gap.
  3. J

    Sea Ray Capacity Plate

    Does anyone know where I can get a Maxium Capacity Sticker/Plate for a 1995 Sea Ray 195 b/r. I checked with Sea Ray & my Local dealer & was told that it is NO LONGER AVAILABLE. They told me to go to a Graphix shop & get one made up, The problem is I DO NOT KNOW WHAT IT SAID (VERY, VERY BADLY...
  4. J

    Sea Ray Capacity Plate.

    Does anyone know where I can get a Maxium Capacity Sticker/Plate for a 1995 Sea Ray 195 b/r, As mine is VERY, VERY BADLY FADED. I checked with Sea Ray & was told it's was available through the Dealer. Went to the Dealer & was told IT'S NO LONGER AVAILABLE, So I contacted Sea Ray yet again & this...
  5. J

    Merc. Alpha 1 trim PROBLEM

    I have a 95 Sea Ray 195 b/r with a 4.3LX & Alpaha 1 gen 2 outdrive. I was cleaning the engine compartment & noticed 2 BLACK wire's (1 male & 1 female) laying there not connected to anything near the Trim pump area, the wire's are going into the transom. Would this be for the trim Limit sensor ...
  6. J

    Mercruiser Tilt/Trim

    I have a 95 Sea Ray 195 b/r with a 4.3. I am having a problem with the tilt/Trim going up. From the shifter it goes down, But will not go back up. If I use the trailer button it goes up. Where can I start to look ?
  7. J

    4.3 Vortec

    I have a 95 Sea Ray 195 b/r with a Mercruiser 4.3 Vortec That is seized. Does anyone know where I can get a used one in New Jersey. I Purchased a motor off someone & paid him to install it, But he stole my money & Boat.:eek: I found the Boat & the Police took a Report. He also Stripped my Motor...
  8. J

    Mercruiser Alpha Outdrive

    I need some help. I am think of buying a 94 wellcraft with a 4.3 mercruiser. The only problem is that someone stole the outdrive off it. I know the ratio is 1.81, But I don't know if it's a Gen 1 or Gen 2. The owner doesn't know what was on it. ANY HELP WOULD BE GREAT. Thanks Jim
  9. J

    Exhaust bellow leaks

    I have a 90 bayliner with a L-Drive 120hp(enough said). Any way I replaced the exhaust bellow hose a few months ago, I took it out of the water to clean & flush the motor. I put the whole outdrive in a large bucket with the hose running. I look'd under & seen water coming out from where the hose...
  10. J

    Force L-Drive 120 fill & vent plugs stuck

    I have a 1990 Force L-Drive 120 I am trying to take out the fill & vent plugs so I can change the gear case oil. I got the drain loose but that's it. I tried A impact screw driver (the one you hit with a hammer),a big fat screw driver & nothing seems to break it loose. Does anyone have any...
  11. J

    Force L-Drive 120 i/b or o/b

    Is the force L-Drive a inboard or outboard. I know it's inside the boat,but it's a 2 stroke 4 cyl. & all the outdrive manuals have it in there
  12. J

    Force L-Drive 120 backfire arrestor

    Does anybody know if the force L-Drive 120 has a backfire flame arrestor on it. I cant seem to find it. I know gas i/o's are suppose to have them.
See more
Top