1994 25hp Yamaha getting water in the lower unit.<br />Model #c25mshr<br />Code #6955 <br />S/N #038854 <br /><br />Any thoughts on were this could be coming from, or what i could check? Trying to find a manual now on this engine before i start taking the block apart.<br /><br />Thanks
Have a 1967 Evinrude. Anyone know of a website that has an online parts list. I have the Service Manual, but it does not list part #'s for the parts.<br /><br />Thanks
Where can i find the special tools to find a Seal Puller and a Bushing punch?<br /><br />I'm trying to change the Seals and O'Rings in a 9.5 Evinrude and can't fing these two speacial tools. I tried NAPA already but no help.<br /><br />thanks
Where can i find the special tools to find a Seal Puller and a Bushing punch?<br /><br />I'm trying to change the Seals and O'Rings in a 9.5 Evinrude and can't fing these two speacial tools. I tried NAPA already but no help.<br /><br />thanks
Does anyone have any experience with these Smart Trim Tabs. They automatically rise when you reach WOT. I think you can set the resistance on the actuators to achieve this.<br /><br />But I'm worried about getting stuck in Low water or Mud, and being unable to back up because the tabs will be...
Does anyone have any experience with these Smart Trim Tabs. They automatically rise when you reach WOT. I think you can set the resistance on the actuators to achieve this.<br /><br />But I'm worried about getting stuck in Low water or Mud, and being unable to back up because the tabs will be...
If you set my boat on a flat surface, neither the bow nor the stern would touch the floor. Because of this the Bow rises a little more and the stern diggs in a little more than I would like.<br /><br />The motor is running good now. I had to raise it about two inches to get it in the right...
I built my own boat. According to plans, the transom was cut to be 15" tall, which made since because I thought a short shaft motor was 15" measuring from the place were the motor rest on the top of the transom down to the top of the cavitaion plate. <br /><br />Well I did not have a motor when...
I know this is basic, but please bear with. Does the 50:1 oil/gas ratio mean add 16 oz oil to 6 gallons of gas? Or 8 oz to 6 gallons?<br /><br />Thanks
Is is possible to add a charging system to an outboard that did not come with one? <br /><br />To clarify, i'm wanting to charge my battery while running my motor.<br /><br />Thanks :confused:
Howdy, i want to change the oil in the lower unit for my new (1967) evinrude 9.5 hp sportwin. Does anyone have any suggestions for what type of oil I should use. Is there a special type for these older motors? And will it take only one regular size bottle to do the job.<br /><br />Also, can...
Just picked up a 9.5 sportwin model MQ-13M and serial J2728701. I would like to know of a website were i can find this info or maybe someone has it handy already.<br /><br />Thanks a bunch..<br /><br />Joey
