I have an 88ish 15hp 2 stroke Merc that belongs to a friend of mine. It will start and idle great, but at anything much over idle, it just bogs and dies. The fuel bulb is constantly firm at all times, before/after/etc, the fuel filter bowl shows no signs of air in the system. If you take a can...
A friend of mine just picked up a Johnson outboard at an auction. It's going to need some parts so we need to identify it. The problem is the Mod/Serial plate is missing. All we have to go by is the serial on the freeze plug. That number is E3435191. Is there any way to identify this motor by...
I was recently given this motor with no manual. Every outboard I've dealt with in the past, had a moveable tilt pin, so this design is totally foreign to me. I'm not sure if it's working properly or not because I don't know what the 3 positions are supposed to do, and I can not see any...
I need to remove the prop shaft on my 1989 8hp Mercury. The manual shows the use of a special tool (bearing carrier tool 91-13664). Doing some searching on here and the net, it seems there is an alternate method that involves using the thrust hub to remove the bearing carrier and there is the...
A friend has a Mercury outboard that was given to him. The serial (freeze plug) is C208505. From what I've found, I believe it's a 1989 model. What I haven't been able to determine is what HP rating this motor is. It seems that the 6, 8, 9.9, and 15 hp all use the same parts with the exception...
I'm working on a 9.9 johnson that is in need of some parts. My buddy read the model number off while I was writing it down. The problem is, that it's not converting to a year model correctly for some reason. I'm not sure if he read the numbers incorrectly or maybe I heard him wrong and wrote the...
I have a 1975 Mercury 200 20hp that was previously set up for remote steer. I would like to convert it back to tiller steer. I have the parts needed, but need some help. What is the easiest way to get at the 3 nuts that bolt the tiller mount bracket to the motor. The 3 bolts and nuts in question...
I have a 75 Merc 200 #4293438. I received this boat and motor with several problems. The remote control connections were some re-engineered concoction done by a previous owner that I am attempting to correct to the best of my ability without spending too much money on it. I've got the throttle...
