I got the port engine reset today and sitting around 750 so i feel much better. Was/am still trying to figure out the stbd eng. Since I replaced the intake been having issues getting it started. Bone head move on my part I actually put the wires in the wrong order. I figured that out but it...
So just wondering....I unplugged the IAC and the TPS and nothing but a little shudder but as soon as I unplugged the MAP sensor it chocked off. Is it supposed to do that?
I didnt either but the RPMs are a worry. It jerks into gear as it should with that high of a range. Just want to tone it down a little back to where it should be.
R
Joe
https://www.amazon.com/gp/product/B074FSZWVT/ref=ppx_yo_dt_b_asin_title_o09_s00?ie=UTF8&psc=1
I did away with the block and put these in instead. A little more heavy duty than the blocks that come with the engine...
Thanks will check it out tomorrow. Was not sure if it was a ecm issue with going from 5.0 to 5.7 but could not see that being it. I did have to rebuild the entire wiring harness since they are not available anymore which sucked for certain.
Swapped out two 5.0 block for 5.7 blocks over the last year due to sitting for so long and water intrusion. They are both TBI engines and not carbed. 2000 model PEFS is the serial number in them and trying to figure out the high idle issue I have. Not sure how to adjust the idle, the engines are...
After two months in the grueling Va heat with an occasional sunday off for golf...who am i kidding every sunday for golf..Anyway back to my story..Got both engines up and running with little to no issues today. There are a couple small issues that are still hanging over my head..
1) STBD Engine...
So I just replaced my VP 305's with 350's and having the same issue on both engines. 5.7 GiPEFS is the engines I am working on. I have been beating myself up for 2 days now trying to get them to start. I have checked all forums and done extensive electrical testing to ensure there is power...
Replacing the engines in my 2000 Chris Craft 308 305';s with 350's. Almost done installing them but am stumped by this last hose and have no idea where it goes. I am running Volvo DP-SM outdrives and just rebuilt the chevy 350s to power it. There is a fitting on top of the thermostat housing...
Well after a year without a boat I really did it this time. I Bought a boat that has been sitting untouched for 5 years. Got a great deal on it and automatic equity as soon as we get her finished. Right now her Name Is Chelsea however we are going to rename her Family Affair once we get ready to...
I am repowering my new to me Chris Craft 308 which has twins 5.0 engines and volvo dual prop outdrives. I am ordering the engines this week but not sure what to order. I am wondering if they are both standard rotation or one is reveres? Also how do I tell which is which in the boat? Both engines...
So I am way into the tear down part of my project but before I go and sit at Fastenal to replace all the bolts I have taken off. I was wondering if there is a kit already made somewhere with all the fasteners I am going to need during my rebuild? I know I can get riser and exhaust bolts just...
