it was turning over but then it stopped and had nothing no roll over no click no nothing, i put screw driver across 2 big bolts on solenoid rolled over for a few sec. then nothing it would not roll over
26 ft peterborough 260 hp 350 mercruiser that does not start after i rolled it over for 15sec. i tried again got nothing no click no dash lights nothing read there is a 90 amp fuse on starter that will do this on starter but can not locate oping somebody can help me. i found 50 amp breaker has...
i see y it is not pumping the hole in water pump is out of round, what did i forget to install or i installed wrong to make it go out of round hoping it is a bushing somewhere.
i will get pic today but when running was not draining tub so figured must of put impeller in backwards when i took off bottom end water was present, there should be no water in bottom end is that correct or does some get into bottom end but not gear case
me again on same ? as earlier if i take cover off rad. can i see the water flowing. i have hot water coming out the back when i put hose on and when i touch rad it is hot, even with water off and bottom end in bucket water coming out the back so not really sure if i am running off close system...
want to thank all for the help i got it back together and after playing with shift interrupter i now have forward reverse and neutral so thanks again for the help a little cosmetic work paint bottom and i am in
i am looking at a whole new reconditioned outdrive but it is off a 6cyl and mine is a 8 appears they have different ratio (not sure what that means) but what happens if i change to this think 184 compared 147 thanking u in advance for your time
hi me again between week of rain and life been away fr outdrive for awhile. but back at it, got upper installed and when installing lower unit i get to 1/2 to 3/4 of an inch away from closed and prop turns as it should in forward go another 1/8 to 1/4 and prop no longer turns seem to have...
found out it is sealed bearing went in nice, went to put top end was going on nice noticed. a little tear in gasket, so i have another thought i would take it off and put new 1 on now i go to put top end on goes on till it gets to threads and now it will not move in or out any ideas how to remove
ty for that, i have a hole in the side of gimbel bearing but can not get grease into it i checked it seems like it is sealed inside reading saying new ones are sealed just want to make sure before i put it in any help is appreciated.
