Recent content by johnmogs

  1. J

    Control Box - tilt/trim switch replacement

    I've got a 1990-ish white OMC (Johnson/Evenrude) control box for my 1993 60hp Evinrude. Trying to replace the tilt/trim switch in the lever/handle but cannot figure out how to disassemble the lever. I've had the box apart but cannot remove the lever. If anyone has instructions or diagram I...
  2. J

    1994 5.8L EFI, wiring and OMC or Volvo drive questions

    I've surfed enough here to know most guys will tell me to run from the OMC/Ford, but I think i've got a sweet enough deal to consider it further, pending answers to my below questions. Thank you in advance! 1994 Four Winns Candia 214 Engine Model #58FACPCMDM, SN: T01273156 Outdrive Model #...
  3. J

    T-stat replacement, wax everwhere, do I need to flush coolant? 180hp, 3.7L, 4cyl Ford

    180hp 3.7L, 4cyl, 1987 MerCruiser IO, with 4" heat exchanger so it's using coolant. Engine SN: B748434 Just purchased a 1987 4Winns Candia and have had it running, went around the lake but the temp gauge wasn't moving, so I stopped. Gauge works when shorting the sender wire to ground, so I...
  4. J

    Gel repair on 1987 Four Winns Candia

    1987 Four Winns Candia 200, Hi, First time post for me, but have learned a lot on the engine side, I have no experience with fiberglass so I'm hopeful this is not that hard of a project. Previous owner's dock had damaged front exterior of boat, he primed it white, unfortunately not prepped...
See more
Top