Recent content by johno77

Hi Guys thanks for both your help. Hopefully you see this message. Its been about 7months since working on the motor. My memory is hasie and I think i may have documented a video Of the last problem on had on the engine. (Well I hope I did a video)that will help me. Okay so what I can remember...

, two blue ,two red, two yellow and one black

Just wondering is there supposed to be continuity between the black ground to red/white? their also continuity from black to single red on the stator

cheers

Thanks Good idea

does that involve all the wires including the wires that go to the coils?

I did some more testing, dva tested trigger, stator ,coils and packs. All tested good apart from trigger low voltage 2.2v.I then removed idle/stabilizer wires and voltage came back up to spec on trigger. I also did this test(not in the merc manual I have). Hopefully I worded it correct. I...

I get confused easy haha. Ill send a video link hopefully tomorrow .

okay slowly learning the regulator and rectifier are two different things yeah? I just haven't read about them yet in the book I have. My workshop manual in some parts bit hard to understand its fallen to bits.Is the idle stabilizer on top or on the port side? There's two black boxes that look...

Thanks for the reply 16amp Oh and its a 1989 model

Hi, I am having problems with my mercury 200HP.1989 not 1998 I redid the carbys 2 years ago. The engine has been sitting. I took it out a few weeks ago. I put in fresh fuel and some sea foam. I ran it on the muffs a few times during the week before heading out. Most of the carbon was gone. Not...

Thanks for the reply. Washer goes on top of bottom yoke will I have to take power head of ?

I replaced my old swivel arm bracket about 18months ago.Iv finally got around to putting lower unit back on.Looking in my box of parts I noticed a wave washer.Looking at swivel arm bracket looks like I did not put it in. Would this cause problems if I was to leave it of? And if i do put the...

Looks to be fiber glass, ply then gelcoat.

Holes are bigger then what I said probably 6-7mm bigger. Here is a link to videos Thanks for your time.