I replaced the impeller and roll pin on drive shaft when I took off lower unit( because it was snapped), now it’s pissing good but is bogging and cuts out after a minute of running. I’m thinking of running sea foam through it to try and clean up carbs and jets, is there something else I should...
I just recently got a 1980 Johnson 6hp 2 cycle and it starts right up but is not pissing. There’s air coming out of the telltale but I’m afraid to run it more than a few seconds without water coming out. I’m thinking I need to replace the impeller but and by no means an outboard mechanic. Is...