I put a tilt switch at the motor, i ran a hot wire to switch center 1 side to green the other to the blue.
when i hit the witch nothing happens, what did i do wrong it bypassed the solenoids.
i just put in a new temperate warning switch now the beeeeeeeeeeeeeeeeeeeeeeeeeeeeep wont stop. I replaced it due to the wire was frayed. It was new out of the package. So i unhooked the blk wire (ground) from the head then it stopped. does this mean my temperate warning switch is bad? I was...
Hello fellas, I'm back with a bag full of questions.
I got a blues seas automatic charging relay an I'm
Stumped, on 1 hand blue seas says I don't need a battery
Switch them on the other it's recommended.
My thinking is, if its automatic then I don't...
It has a isolation feature. I've look all...
Hello forums its been a while since i last checked in.
I have a quick question i hope. I replaced the poppet in my 88 v6 135
an all the parts that go with it. so my question is, when i screwed the washer the diaphragm and the water deflector to the back end of the poppet, the screw didn't go in...
Re: New Oil Warning Module issues
Got off work early had some time to kill so I pulled the oil pump off took out the cap that holds the magnet and then pulled the shaft out.
The first thing, my shaft is not plastic, its harden steel. it looks good will post a picture.
The cap that sits on the...
Hey I just got a new Oil Warning Module, my issue is on the box 41470A25
but on the module itself is has 41470A22. Are these one in the same or did someone make a mistake some where along the line. I don't want to put it on until I know for sure, you know how they are about electric parts. :eek:
I have a 1988 V6 135 Sea Ray Edition. with the old clam shell housing. I'm going to replace the poppet valve. But how in de hell do I move the lower part of the clam shell out the way. Its a one piece.(I hate those)
Also I have been noticing when I run it off the hose it seams as if its not...
My alarm is till crying, been running mixed gas.
Any who, today I pulled off the supply line from the pump that goes to the carbs. @ 1500 to 2500 RPMs to check oil flow. after about 3 minutes I got about enough to fill a coke cola cap. Is that right? It has a new gear shaft in it. Pump im...
Does anyone have some plans on how to build a Convertible top, i know its pretty simple but its easier for me if i have something to reference somebody stole mine and cant find one to save my life.
I'm looking for a convertible top frame that will fit my boat its 69 inches across somebody stole mine from where i keep my boat parked. I've checked the internet but mine was a navy top and i cant find one of those anywhere.:mad:
Re: Temp and Oil Warning System
Well that sucks no return on those parts and I believe mine is bad. I went through that process and the beeping started with the warning wire was hooked up. I even disconnected the the cap wires. Still beeping. Could it be the pump?, but the tank is full and my...
A couple weeks ago I was on a search mission to find out why the warning buzzer was not buzzing. Found out why. My controls was replaced and it was replaced controls for a stern drive so they added a alarm buzzer moddual. Today I put in 2 new T-stats 143 degree per spec sheet. New cover plate...
