http://imgur.com/nVuWjgg&JKz1WPy&wbRnt8T&pvcnoAb&r6UWLOe&LGAUXuh#0
Did I not install this right. It is stopping at an angle instead of straight up and down. It does not look like I need to move the unit up the bow anymore than it already is. Is it suppose to be at an angle like this?
Would this be possible by just bolting to steel rods (making them removable) to the front and back?
Would the center of gravity be thrown off as it would swing with the waves?
http://imgur.com/pX7hPQ9 Here she is.
I got this boat about 10 years ago and have not done much to it. I replaced the transom wood, re riveted a few holes and cleaned it up a bit.
This boat has a small aluminum plate over the bow and used to have a seat installed at the tip. I was in the...
imgur: the simple image sharer - Here she is.
I got this boat about 10 years ago and have not done much to it. I replaced the transom wood, re riveted a few holes and cleaned it up a bit.
This boat has a small aluminum plate over the bow and used to have a seat installed at the tip. I was in...
So it was working fine. I started the motor started to give it gas and it basically went forward and then popped out of gear. Now it will not move forward or reverse. Just stays in neutral. I cannot figure it out. I can't really find the issue I'm having in the manual either. It's a 85ish year...
ok I have a 1964 Evinrude 18hp. It ran great. Only problem was the cooling system was not working right. Long story short I got some bad advice from the dealer and I ended over heating my engine pretty bad. Started to loose power, cut it off and hissing bad. So my first question is how does the...
http://s19.photobucket.com/albums/b161/josh6780/project%20pontoon/
I bought it for 1500 from my friends granddad. He basically bought the boat and used it like maybe 10 times in the span of all the years he has had it. Never covered it up. So the engine has only a few hours on it. (its a 90hp)...
So I stripped the paint and I had to get my something off my face. So I spun myself up a mirror. Now look at those scratches from the puddy knife! I also have little specs of paint I still have to get off. What is the best way to get the paint off and the scratches out...
so here is what I am going to do with my boat. What is the best way to do it?
the bottom part is going to be harder than the side. So do you think I should sand it. Or just keep polishing till it looks like the side.
Here is a pic...
I am thinking about buying my friends granddads pontoon boat. What do you think I should offer him? The floor feels pretty solid. Engine works fine. 70HP. Does not come with a trailer.
Ill have to do some rewiring, new carpet, seats. All that stuff.
http://s19.photobucket.com/albums/b161/josh6780/
I am wanting to build a tube water slide that goes into the lake. I have a a very steep hill thats about 40 feet down. I want to put a tube slide or a slide that will go all the way down and into the lake. I don't know where to look to find information about this. Is there a place where I can...
