Recent content by JPsanta

  1. J

    cooling system

    on the front of the exhaust manifold theres a hose that runs to the back of the manifold , why would it be like that
  2. J

    cooling system

    no , not over heating , just trying to find a cooling diagram for it , to see the water flow
  3. J

    cooling system

    here are a few pics
  4. J

    cooling system

    HI . have a fiber boat , its around a 1979 , looking for a cooling diagram, engine is a 351 ford , not sure if its a commander but the exhaust logs have commander on them.there are no tags on motor or drive. Outdrive is a volvo penta. would be thankfull for all and any help
  5. J

    Volvo Penta Ford help

    this boat is a fibra , 23 ft , guy said it was a 351 engine
  6. J

    Volvo Penta Ford help

    bought a boat with a 8 cylinder ford in it , not sure the year or horse power , no tags on motor that i can find , has a volvo penta stern drive , nothing on it either the boat is a 1979 thats all i know HELP
  7. J

    1977 6 hp Johnson

    copper tube is in place , water is above impeller postion
  8. J

    1977 6 hp Johnson

    put in new impeller , have water coming out of upper exhaust , but not water coming out pee hole , pulled thermostat and no water there either , need help JP
  9. J

    18hp evinrude bad cough

    pretty sure compression was 120 on both cylinders
  10. J

    18hp evinrude bad cough

    hi guys , have a 1966 18 hp evinrude , seems not to run to bad butt has a bad cough at low speed , but new carb kit in it , checked plugs when got home , top plug was very black , bottom was clean , any ideas
  11. J

    1977 6 hp johnson waterpump

    what is PW and vermitherm
  12. J

    1977 6 hp johnson waterpump

    yes , key is in place , will try it again
  13. J

    1977 6 hp johnson waterpump

    no , copper tube stayed in place
  14. J

    1977 6 hp johnson waterpump

    hi guys , need help , 77 6 hp johnson , fired it up and no water coming out pea hole , replace waterpump with new kit , put back together still no water, took apart to test it , put in bucket water turn shaft with drill , water pump worked , put back together no water , pulled thermostate , no...
  15. J

    Need to ID motor

    the screw is up where the cap is on rh side , the cap to remove the unit , you have to lift unit all the way up , then look up in there, not by ball gear
See more
Top