Recent content by jrenneker

Thanks for the heads up but it doesn't look like the same part I'm looking for. Mine is an actual jet.

I figured I would show at least one picture in case someone recognizes the part. It is just the two broken pieces at the bottom of the picture.

Ok so now I'm stalled. I'm working on a stainless back cap to finish the look of the transom which should be done soon. Anyway, last week I started and ran the motor for awhile. Sounded descent but a little rough. So I was going to clean the carbs and I broke the Main Jet Bolt that holds the...

The speakers I picked up have built in led's which has a boat load of colors to choose from. The seats I picked up from Cabela's and they are very comfortable.

I picked up some wise seat pedestals and I think they are awesome and very reasonable on price.

Fish finder all hooked up along with the radio!

I also painted up the throttle.

The Chrysler that is all cleaned up and painted.

I bought a new circuit breaker/switch panel. It was really easy to work with and I was able to move the breakers around so I could arrange it to my preference.

Then glassed and carpeted!

New speakers all wired up!

Then for the fun/pain in the... Carpet!! It went together a lot better than I was expecting. I love the way it turned out. One problem that arose was some of the doors were too big for the carpet being wrapped around them. So I had to trim off about 1/4" so they fit snug and I didn't need...

I also did it for the front stabilizing piece. This one was tricky because the floor went from 1/2" to 3/4" so I cut it big and sanded until it fit.

Same goes for the channel that my electrical and cables run through.

I used all my old cabinet doors as templates and made all new ones. Then I glassed them.