I have a 1988 sport craft 270 hardtop. It has a straight drive vortec 350 borg warner velvet drive. The prop shaft was in need of replacement so I have a new one as well as a new coupler
a new cutlass bearing. I also upgraded to a last drop prop shaft seal it has a cutlass bearing in it. I had...
I have a 2000 ficht 225. I was checking voltages at the PDP. There is a Red wire with a black stripe. the manual says it is batt accessory fuseable link. I get no voltage reading on it with the key turned. This wire goes to the EMM. Is this correct?
I am trying to get my computer to communicate with the engine and it will not. I have the cable attached to a plug on the starboard side of the engine just behind the pdp. It has the same color wires but it was not unused or free. It was connected but it only had one wire cumming out of it...
I have a 2000 ficht evinrude 225. all the relays are working. fuel pump cycles. check lights cycle as they should. EMM is getting power. pdp shows all circuits good according to manual. I have cleaned all connections and grounds. I changed the fuel filter and the lift pump and electric pump...
i recently bought a 2000 225 evinrude. The engine spins over but I am not getting any spark and the electric fuel pump does not come on. I got the manual and i have been reading a bunch in this forum. I understand the emm can be a problem. I can not seem to find a way to check it. I will...
